User manual KAZ PRO 4000

[. . . ] When the Braun ThermoScan is placed in the ear, it continuously monitors the infrared radiation until a temperature equilibrium has been reached and an accurate reading can be taken. Clinical studies have shown that the ear is an excellent site for temperature measurement because temperatures taken in the ear reflect the body's core temperature. Body temperature is regulated by the hypothalamus, which shares the same blood supply as the tympanic membrane. Changes in core body temperature, are usually seen sooner at the tympanic membrane than at other sites, such as the rectum, mouth or under the arm. [. . . ] Your Braun ThermoScan is shipped with the Celsius temperature scale activated. If you whish to switch to Fahrenheit (°F), proceed as follows: Make sure the thermometer is turned off. press and hold down the «I/O» button. After about 3 seconds the display will show this sequence: «°C» / «SET» / «°F» / «SET» . Release the «I/O» button when «°F» is shown. There will be a short beep to confirm the new setting, then the thermometer is turned off automatically. When turned on again, temperatures will be shown in Fahrenheit, until the above procedure is repeated. For your Braun ThermoScan PRO 4000, there is a Base Station available. contact your distributor for details (see page 2). The station automatically recharges the thermometer (when using the rechargeable batteries supplied with the base station), and it has an electronic, individually adjustable anti-theft function. When leaving the factory, the anti-theft function of the PRO 4000 is turned off. If the anti-theft function is enabled, and when not in the measuring process (stand-by mode) the thermometer will show the time remaining before it is locked. for turning on the anti-theft function , please refer to the base station manual. If the thermometer shows «RET» (without the battery symbol) on its display, the anti-theft time has elapsed and the thermometer must be returned to the station for unlocking. If the anti-theft function is not enabled, the display will show «off» when in stand-by mode. Braun ThermoScan probe covers are intended for single use only!To ensure accurate readings, always use Braun ThermoScan disposable probe covers with the Pro 4000 thermometer. damaged , perforated , or soiled probe covers can lead to inaccurate temperature readings. Additionally, the accuracy of your temperature readings can be affected by damage to the probe window, or the presence of dirt and ear wax on the probe window. To assure a high level of accuracy, it is very important to keep this window clean, dry and undamaged. Fingerprints, earwax, dust and other soiling compounds reduce transparency of the window and result in lower temperature readings. If the thermometer is accidentally placed in the ear without a probe cover installed, the window must be cleaned immediately. [. . . ] This guarantee extends to every country where this appliance is supplied by Braun or its appointed distributor. This guarantee does not cover: damage due to improper use, normal wear or use as well as defects that have a negligible effect on the value or operation of the appliance. The guarantee becomes void if repairs are undertaken by unauthorised persons and if original Braun parts are not used. To obtain service within the guarantee period, hand in or send the complete appliance with your sales receipt to an authorised Service Centre or the Welch Allyn Customer Service (see page 2). [. . . ]