User manual KAZ V977

[. . . ] Re-measure with a standard digital thermometer for confirmation, especially on infants (It is recommended use a digital thermometer rectally on infants and on sleeping infants if there is a question about the measurement. Be sure to note this unit reads 1°F lower than a rectal digital measurement). · · Forehead Thermometer Instruction Manual Thank you for purchasing the Vicks Forehead Thermometer (V977). The Forehead Thermometer is a high quality product incorporating the latest technology and tested in accordance with international standards. With its unique technology, the Forehead Thermometer can provide a stable, heat-interference-free reading with each measurement. [. . . ] WARNING: · Use of this Forehead Thermometer is not intended as a substitute for consultation with your physician or pediatrician. Product Description (1) Power Button (2) Scanner (3) LCD Display (4) memory Button (5) Battery Cover (6) Protective Scanner Cap (5) (3) (4) (1) (6) (2) 4. How the Forehead Thermometer measures Body Temperature The Forehead Thermometer measures infrared energy radiated from the skin above of the eyebrow area and the surrounding tissue. This energy is collected through the lens and converted to a temperature value. Temperature readings obtained by scanning above the eyebrow area will provide the greatest accuracy. The Forehead Thermometer has been clinically tested and proven to be safe and accurate when used in accordance with its operating instruction manual. 5. Control Displays and Symbols LCD Display Display meaning Self check ensures proper functioning Description Press the On/Off button to run on the unit, all segments will be shown for 2 seconds. The last reading will be shown on the display automatically for 3 seconds. The unit is ready for the measurement, the °F icon will keep flashing. The reading will be shown on the LCD display with the °F icon flashing, the unit is ready again for the next measurement. When the unit is turned on, the battery icon will keep flashing to remind the user to replace the batteries. Recall of last reading Ready to measure Measurement complete Low battery indication 6. Press the Power button on front of unit. The LCD is activated to show all segments for 2 seconds. The last measurement reading will be shown on the display automatically for 3 seconds with the «M» icon. When the °F icon is flashing, a beep sound is heard and the thermometer is ready for the measurement. Place the probe gently and flush onto the area approximately 1/2 inch above the center of the eyebrow. If the eyebrow area is covered with hair, sweat or dirt, please clean the area beforehand to improve the (4) reading accuracy. Press the Power button once and release it. Start to move the instrument steadily from 1/2 inch above the center of the eyebrow to 1/2 inch above the tail of the eyebrow area and back up again. A long (5) beep will sound after 3 seconds to signal measurement complete. If the probe movement is too slow to reach the tail of the eyebrow before the long beep sound is heard, repeat the measurement as (6) above from step 4, and move the probe a little quicker this time. Read the recorded temperature from the LCD display. To avoid an inaccurate measurement, note the following: · Patients should stay in steady - state room condition for at least 30 minutes. [. . . ] Replace the batteries being sure to align properly as indicated inside the battery compartment. Remove the battery from the instrument if it is not required for extended periods of time in order to avoid damage to the thermometer resulting from a leaking battery. Dispose of batteries according to local waste management directions. 11. Warranty Your Forehead Thermometer is durable and manufactured for normal, household use. [. . . ]