User manual KENMORE 625.343920

[. . . ] 625. 343920 625. 343950 (DELUXE) Caution: Read and Follow All Safety Rules, Installation and Operating Instructions Before First Use of This Product. UNDERSINK DRINKING WATER FILTER SYSTEM Safety Guides Installation Operation Cartridge Replacement Repair Parts If you have questions when installing and using your drinking water filter system, call this toll­free number. . . 1 ­ 800 ­ 426 ­ 9345 SAVE THIS MANUAL Sears, Roebuck and Co. , Hoffman Estates, IL 60179 USA SAFETY GUIDES / SPECIFICATIONS Please read this entire manual before installing and using your undersink drinking water filter system. Be sure to follow all guides and rules carefully. Failure to follow them could cause personal injury or property damage. [. . . ] Then, with the washer in place, turn the tub ing adaptor onto the valve and tighten securely. Note: Be sure the valve packing nut is tightened. Do not turn on the water supply at this time. FIG. 2 Check local codes for approval SINK nut (2) ­ not req'd with all types of clamp B pre­drill 1/8" hole (iron pipe) cold water seal clamp A valve washer adaptor handle STEP 2 - MAKE HOLE FOR FILTERED WATER FAUCET Select 1 of the following places to install the faucet. Be sure there's room underneath so you can make the needed connections. If you are installing the deluxe model, be sure the electronic indicator base will fit flat against the surface. -- In an existing sink spray attachment hole. -- Drill a hole in the countertop, next to the sink. If drilling is needed, make a 3/4'" dia. The faucet with the elec tronic indicator base requires a 1-1/8" dia. hole. CAUTION: To avoid damaging the sink, consult a qualified plumber or installer for drilling procedures in porcelain or stainless steel. Place plumbers putty around the drilled hole, to prevent water leaks around the faucet. FIG. (standard faucet) or 1­1/8" dia. (electronic base faucet) hole through sink or countertop plumbers putty 5 INSTALLATION STEPS STEP 3 - ASSEMBLE AND INSTALL FAUCET Note: If the faucet is not assembled, slide the lever over the cylindrical nut. Then, push or turn the spout into the faucet body. Slide the chrome washer, large rubber washer and lock washer, in that order, onto the faucet stud. Put a few wraps of Teflon tape on the end of the faucet stud. Using the washer, turn the tubing adaptor onto the faucet stud and tighten securely. On the underside of the sink or countertop, in sert the large steel washer between the lock washer and the bottom of the sink or countertop. Insert the faucet stud through the mounting hole. 4 A MODEL 625. 343920 spout spout lever faucet screw chrome washer rubber washer (large) steel washer (large) lock washer hex nut rubber washer electronic faucet base hex nut B DELUXE MODEL 625. 343950 washer tubing adaptor B. Put a few wraps of Teflon tape on the end of the faucet stud. [. . . ] Note: If the sump will not tighten up to the head, you may have the cartridge in upside down. Take the car tridge out and check for correct orientation. Being careful not to cross-thread, turn (counter clockwise) the sump onto the filter head and tighten securely. Repeat steps 2 through 7 at the other filter. Filter II TURN SUMP COUNTERCLOCKWISE TO TIGHTEN 9. [. . . ]