User manual KENMORE ELECTRIC ROTARY SEWING MACHINE

[. . . ] Call your authorizeddealer or service center when you havequestionsor need service. When you call, you will need the microwavehood model and serial numbers. Both numberscan be found on the model/serial rating plate locatedbehind the microwave ovendoor on the front frame of the microwaveoven. Yoursafety and the safety of others are very important. [. . . ] Wall and roofcaps must have back-draftdamper. we recommend: v' using rigid metal vent. V' that length of vent and number of elbows should be kept to a minimum to provide efficient performance. V' that size of vent should be uniform. v' using duct tape to seal all joints in the vent system. V' using caulking compound to seal exterior wall or roof opening around cap. V' two elbows should not be installed together. we do NOT recommend: v' flexible metal vent. NOTE: If flexible metal vent must be used, calculate each foot of flexible metal vent as two feet of rigid metal vent. Flexible metal elbows count twice as much as standard elbows. The total length of the vent system including straight vent, elbow, transitions, wall or roof caps must not exceed the equivalent of 140 feet of 3-1/4" X 10" rectangular or 6" diameter round vent. Line up paper wall template centerline with centerline on wall. Top of template must be located a minimum of 66" from floor. note: · If front edge of cabinet is lower than back edge, adjust top of wall template to be level with front edge. Rear wall pared traseta Top of wall template must align with front edge of cabinet. Find and mark the location of all wall studs on wall template. If there are no wall studs in the opening area, DO NOT install microwave hood. Placethe Upper cabinet template against the bottom of the upper cabinet. The "rear wall" arrows mustbe againstthe rear wall sothat the holes cut in the cabinetbottomand the holes in the top of the microwavecabinetwill align. If the cabinet bottom has a frame around it, trim the template edges so that the template fits inside the frame against the cabinet bottom. The template has trim lines to use as guides. Important:The 10-7/16" dimension from the rear wall to holes "J" and "K" mustbe maintained. [. . . ] Install vent through vent opening in wall. Use caulking to seal wall opening around exhaust cap. Leaveenough space for the toggle to go through wall and open. Push toggle bolts ® and nuts ® through the drywall ®. [. . . ]