User manual KENWOOD CCD-2000

[. . . ] Model CCD-2000/CMOS-200 Serial number To prevent injury or fire, take the following precautions: To prevent a short circuit, never put or leave any metallic objects (such as coins or metal tools) inside the unit. Before drilling any mounting holes always check behind where you want to drill the holes. Do not drill into the gas line, brake line, electrical wiring or other important parts. If this unit is installed in the passenger compartment, anchor it securely so it does not break free while the car is moving, and cause injury or an accident. [. . . ] - Places that may be splashed by rain, for example close to the door. Use corrugated tubes for wiring inside the engine room. If a cord contacts a high-temperature area of the vehicle, the coating may melt and cause short-circuiting, which may lead to a fire or electric shock hazard. The head unit connection cord is used for connection to a Kenwood car navigation system equipped etc. The adjustments during camera setting may be hindered depending on the camera installation position. Do not install the camera securely but attach it only temporarily until the camera setting has completed. If required, separate the camera bracket from the camera and adjust the shape according to the surface on which it will be attached. Fix the camera temporarily with tape, etc. , fix the camera temporarily and adjust the angles so that the rear end of the vehicle can be viewed. Attach the camera on the rear center position of the vehicle taking care not to hide the license plate. Make sure that the camera points straight toward the rear of the vehicle travel direction. Engine key Fuse Accessory power (ACC) Fuse (2A) Do not connect to a permanently ON power supply. If the engine key of your vehicle does not have the ACC position, branch the wire energized when the engine key is ON and connect it to the accessory power cord. Before proceeding to connections, make sure that the engine key is not inserted and disconnect the (-) terminal of the battery to prevent the short-circuiting incident. When connecting the camera to a Kenwood navigation system (head unit) equipped with the camera control function, use the provided head unit connection cord. This allows the head unit to switch the display view and adjust the camera as well. When using two CCD-2000 units (for the front and rear), it is required to set an ID for the front camera. Connect the power supply in the same way as "Basic Connections". The provided switch unit is not used in the system connection. Power supply box Power supply box The switch unit can be used to switch the image display mode, view/hide the guideline display and adjust the camera. Some video monitors may switch automatically to the external video input function. For details, read the instruction manual for your video monitor. [. . . ] As the interval between each set of guidelines varies depending on the camera installation height, check the actual settings after all of the following adjustments are completed. Once the interval between guidelines has been adjusted according to your parking space, the displayed guidelines do no longer indicate the width of the vehicle. Note that the sizes of parking space are greatly variable and confirm the actual size of each parking space before attempting to park in it. After completing the adjustment, press the view button. [. . . ]