User manual KENWOOD CM070

[. . . ] Get it checked or repaired: see `service'. Never put the machine in water or let the cord or plug get wet - you could get an electric shock. Unplug: before filling with water before cleaning after use. [. . . ] on/off switch with indicator light measuring spoon jug hotplate to make coffee 1 Pour water into the tank. The water must be between the top and bottom cup marks. We recommend using filtered water from a Kenwood Water Filter as it reduces limescale. If you use the jug to fill the tank, look at the tank marks, not the jug marks. They're slightly different to allow for the fact that some of the water gets absorbed by the coffee. 3 Add either a permanent filter or a paper filter. Add the coffee, use the spoon provided (approximately 1 level spoon per large cup). 5 Plug in and switch on, the light will glow. 6 Don't remove the jug until brewing has finished. The hotplate will keep your coffee hot, but the sooner you drink it, the better it will taste. 7 When the jug's empty, switch off by pressing the on/off switch. Let the machine cool down before cleaning. If you haven't used the machine for a while, run one lot of water through it (without coffee) to clean it out. Fill the tank to the top cup mark when you do this. Never put the jug in the microwave. 3 After descaling, run several lots of water through the machine to clean it out. Fill the tank to the top cup mark when you do this. 4 Wash the parts. service If the cord is damaged it must, for safety reasons, be replaced by Kenwood or an authorised Kenwood repairer. [. . . ] Don't use abrasives - they'll scratch the plastic. descaling You'll know when limescale has built up because your coffee will take longer to come through. When this happens it's time to descale. Important (UK) only The wires in the cord are coloured as follows: Green and Yellow = Earth Blue = Neutral Brown = Live. [. . . ]