User manual KENWOOD CM662

[. . . ] Get it checked or repaired: See `service and customer care'. Never put the machine in water or let the cord or plug get wet. Watch out for steam and never touch the hotplate. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] Providing the appliance remains connected to the power supply the clock will keep the correct time, if it is unplugged the clock will flash 12:00. Important (UK) only The wires in the cord are coloured as follows: Green and Yellow = Earth Blue = Neutral Brown = Live. This machine complies with European Economic Community Directive 89/336/EEC. to make coffee 1 Pour water into the tank. The water must be between the top and bottom cup marks. We recommend using filtered water from a Kenwood Water Filter as it reduces limescale. If you use the jug to fill the tank, look at the tank marks, not the jug marks. They're slightly different to allow for the fact that some of the water gets absorbed by the coffee. 2 Open the filter door by pressing the release button and insert the filter holder. 3 Add either a permanent filter or a paper filter. Add the coffee (approximately 1 rounded dessertspoon/7g per cup). Model CM660 press the auto/on/off button twice. 6 CM660: to produce stronger coffee press the strength control button. During operation the strength control indicator light will glow for approximately 10 minutes. 7 Don't remove the jug until brewing has finished. The hotplate will keep your coffee hot, but the sooner you drink it, the better it will taste. Model CM660 After 2 hours, power to the hotplate will cease and the auto/on/off indicator light will go out. 8 When the jug's empty, switch off by pressing the on/off switch (CM650) or the auto/on/off button (CM660). Let the machine cool down before cleaning. If you haven't used the machine for a while, run one lot of water through it (without coffee) to clean it out. Fill the tank to the top cup mark when you do this. [. . . ] Fill the tank to the top cup mark when you do this. 4 Wash the parts. service and customer care If the cord is damaged it must, for safety reasons, be replaced by Kenwood or an authorised Kenwood repairer. UK If you need help with: using your machine or servicing, spare parts or repairs (in or out of guarantee) call Kenwood customer care on 023 92392333. Have your model number ready - it's on the underside of the coffee maker. [. . . ]