User manual KENWOOD CMOS-200

[. . . ] Take the time to read through this instruction manual. Familiarity with installation and operation procedures will help you obtain the best performance from your new Universal Camera. Record the serial number, found on the back of the unit, in the spaces designated on the warranty card, and in the space provided below. Refer to the model and serial numbers whenever you call upon your Kenwood dealer for information or service on the product. [. . . ] loosen the camera bracket retaining screws. Using a commercially available Phillips screwdriver, loosen the two retaining screws. Perform steps 4 and 5 only when they are required. Some video monitors may switch automatically to the external video input function. For details, read the instruction manual for your video monitor. change the shift lever to the R (Reverse) range to view the image of the rear of the vehicle. Before viewing the camera, apply the parking brake and chock the wheels so that the vehicle will not move. Otherwise, an unexpected accident may result. Attach double-side adhesive tape on the power supply box and then attach it under the carpet on the front passenger seat side. (CMOS-300 only) If an adjustment is not possible in the currently available range, change the camera position before retrying. Do not attach the power supply box in the following place. - Place that comes in the way of driving. Peel off the paper liner from the double-side adhesive tape on the camera bracket and attach it. After attaching, push the camera bracket with your finger to ensure close adhesion. Do not touch the adhesive surface with your hand or peel and reattach an attached tape, as these will degrade the adhesive force and may cause the camera bracket to be detached. Clean the switch unit installation surface. Using a commercially available cleaner, wipe dirt, moisture and oil away from the surface on which the switch unit is to be attached. Attach double-side adhesive tape on the bottom of the switch unit and then attach it in an easy-to-operate position, for example near the dashboard on the driver seat side. Power supply box When the monitor does not have the rearview camera input and switches the input upon detection, connect to vehicle's reverse lamp harness. Not used when connecting to a navigation system or monitor with a dedicated rearview camera video input. Engine key Fuse Accessory power (ACC) Fuse (2A) Do not connect to a permanently ON power supply. If the engine key of your vehicle does not have the ACC position, branch the wire energized when the engine key is ON and connect it to the accessory power cord. [. . . ] With an image displayed on the monitor, press the view button of the switch unit. Each press switches the image display mode in the following order. Corner View The views seen from the two corners of vehicle are displayed on the left and right halves of the screen. Overhead View Image seen from the viewpoint straight up above the vehicle. [. . . ]