User manual KENWOOD CMOS-310

[. . . ] CMOS-310 CMOS-210 UNIVERSAL MULTI-VIEW CAMERA/ UNIVERSAL REAR VIEW CAMERA INSTRUCTION MANUAL CAMRA MULTI-VUES UNIVERSELLE/ CAMRA DE RECUL UNIVERSELLE MODE D?EMPLOI UNIVERSAL MULTIVIEW-KAMERA/ UNIVERSAL RCKFAHRKAMERA BEDIENUNGSANLEITUNG UNIVERSELE MULTIVIEWCAMERA/ UNIVERSELE ACHTERUITRIJCAMERA GEBRUIKSAANWIJZING TELECAMERA MULTIVISIONE UNIVERSALE/ TELECAMERA PER RETROMARCIA UNIVERSALE ISTRUZIONI PER L?USO CMARA DE MULTIVISIN UNIVERSAL/ CMARA DE VISTA TRASERA UNIVERSAL MANUAL DE INSTRUCCIONES CMARA MULTIVISO UNIVERSAL/ CMARA TRASEIRA UNIVERSAL MANUAL DE INSTRUES ????????/??????? ????? Take the time to read through this instruction manual. Familiarity with installation and operation procedures will help you obtain the best performance from your new Universal Camera. For your records Record the serial number, found on the back of the unit, in the spaces designated on the warranty card, and in the space provided below. Refer to the model and serial numbers whenever you call upon your Kenwood dealer for information or service on the product. [. . . ] Perform steps 4 and 5 only when they are required. 4 | CMOS-310/CMOS-210    DFPKA$ 10 Adjust the camera angle so that the rear part of the vehicle or the rear bumper is visible at the bottom of the monitor screen. 1 2 Clean the switch unit installation surface. Using a commercially available cleaner, wipe dirt, moisture and oil away from the surface on which the switch unit is to be attached. Attach double-side adhesive tape on the bottom of the switch unit and then attach it in an easy-to-operate position, for example near the dashboard on the driver seat side. ??? 12 Perform the operations in ?Camera Setting? (page 8). (CMOS-310 only) If an adjustment is not possible in the currently available range, change the camera position before retrying. the paper liner from the double-side adhesive tape on the camera bracket and attach it. After attaching, push the camera bracket with your ?nger to ensure close adhesion. 28 feet) CAM+ (Green/red) CAM- (Green/white) Engine key Fuse Fuse (2A) Accessory power (ACC) Accessory cord (Red) Connect to the ON-OFF switchable power supply. Do not connect to a permanently ON power supply. Main fuse GND cord (Black) Battery CAUTION ?If the engine key of your vehicle does not have the ACC position, branch the wire energized when the engine key is ON and connect it to the accessory power cord. Before proceeding to connections, make sure that the engine key is not inserted and disconnect the (-) terminal of the battery to prevent the short-circuiting incident. Connect to a metallic part of vehicle (a part of chassis connected to the negative side of power supply). 6 feet) Power cord Switch unit (CMOS-310 only): 1 m (3. This allows the control unit to switch the display view and adjust the camera as well on touch the control unit screen. When using two CMOS-310 units (for the front and rear), it is required to set an ID for the front camera. Connect the power supply in the same way as ?Basic Connections?. The provided switch unit is not used in the system connection. eNGLISH   Connection of 2 Cameras Connect to the dedicated rearview camera video input. Video cord Power cord Camera 1 (Used as rearview camera) (ID1: Default) CAM+ (Green/red) Connect to the camera control terminals of the control unit. [. . . ] Overhead View Image seen from the viewpoint straight up above the vehicle. wide View Camera image covering a horizontal angle of about 135. This allows the control unit to switch the display view as well on touch the control unit screen (page 7). Specifications subject to change without notice. [. . . ]