User manual KENWOOD DDX-8054BT

[. . . ] When removing the product from the box or installing it, the front panel may be positioned at the angle shown in (Fig. If the program that is activated when the product is first powered on works properly, the front panel will automatically move into the position (initial setting angle) shown in (Fig. Reception may drop if there are metal objects near the Bluetooth antenna. [. . . ] Do not press hard on the panel surface when installing the unit to the vehicle. Otherwise scars, damage, or failure may result. Install this unit in the console of your vehicle. Do not touch the metal part of this unit during and shortly after the use of the unit. Metal part such as the heat sink and enclosure become hot. For the sake of safety, be sure to connect the parking sensor. Connect to vehicle's reverse lamp harness when using the optional rear view camera. To use the steering wheel remote control feature, you need to an exclusive remote adapter (not supplied) matches your car is required. When this terminal is not in use, leave its cap on. Connect to the terminal that is grounded when either the telephone rings or during conversation. Connect either to the power control terminal when using the optional power amplifier, or to the antenna control terminal in the vehicle. If no connections are made, do not let the cable come out from the tab. The pin arrangement for the ISO connectors depends on the type of vehicle you drive. Make sure to make the proper connections to prevent damage to the unit. the default connection for the wiring harness is described in 1 below. If the ISO connector pins are set as described in 2, make the connection as illustrated. [. . . ] Be careful to avoid injury from the catch pins on the removal tool. Lower the removal tool toward the bottom, and pull out the unit halfway while pressing towards the inside. Engage the catch pins on the removal tool 5 and remove the two locks on the lower level. [. . . ]