User manual KENWOOD DDX319

[. . . ] Model DDX771/DDX491HD/DDX471HD/DDX371/DDX310BT/DDX319/DDX271/DDX2071 Serial number US Residents Only Register Online Register your Kenwood product at www. 31 V WARNINGS: (To prevent accidents and damage) • DO NOT install any unit or wire any cable in a location where; – it may obstruct the steering wheel and gearshift lever operations. € it may obstruct the operation of safety devices such as air bags. € DO NOT operate the unit while driving. [. . . ] Copying the phone book You can copy the phone book memory of a mobile phone into the unit (up to 400 entries). * This operation works only when <TEL Key Long Press> is set to [Voice]. (Page 48) The phone book memory is copied from the mobile phone. (Page 35) 2 ENGLISH 37 DDX_Entry_K. Indb 37 2013/11/01 16:10 BLUETOOTH About mobile phones compatible with Phone Book Access Profile (PBAP) If your mobile phone supports PBAP, you can display the phone book and call lists on the touch panel screen when the mobile phone is connected. € Phone book: up to 5 000 entries • Dialed calls, received calls, and missed calls: up to 50 entries each To display the phone book/call lists of the mobile phone or the unit Deleting the phone number entries in the unit 1 Display the phone book/call list you want to delete. (Page 36) Settings for Bluetooth mobile phones 1 Display the <Handsfree> screen. (Page 35) 2 2 • You cannot delete data when [Phone] is selected. [Phone] Displays the phone book/call lists on the connected mobile phone. [System] Displays the phone book/call lists copied to the unit. € Press [All] to delete all the numbers/names in the selected list. 1 Display the <Equalizer> screen. On the <Top Menu> screen: <Flat> The adjustments are stored and <User> is activated. <Q Factor> <Bass EXT> <SW Level> Adjusts the width of the frequency. € You can also display the <Tone> screen by pressing AUD (for DDX771/DDX271/DDX2071) or by pressing and holding the Volume/ATT/ AUD knob (for DDX491HD/DDX471HD/DDX371/ DDX310BT/DDX319) on the monitor panel. * Adjustable only when the subwoofer is activated. (Page 46) • You can change the page to display more items by pressing [ ]/[ ]. The adjustments are overwritten if the <User> setting has been created (see the left column), and <User> is activated. € To make adjustment for other bands, repeat step 3. * Adjustable only when the subwoofer is activated. Indb 40 2013/11/01 16:10 SETTINGS Adjusting the crossover frequency 1 Display the <X’over> screen. On the <Top Menu> screen: Adjustment for video playback Adjusting the picture You can adjust the picture quality. [. . . ] Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. The term “IC: ” before the certification/ registration number only signifies that the Industry Canada technical specification were met. CAUTION This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC radio frequency (RF) Exposure Specifications Monitor section Picture Size (W x H) DDX771: 6. 4 lbs) Design and specifications are subject to change without notice. [. . . ]