User manual KENWOOD DDX8034BT

[. . . ] This 2 DNX SERIES/ DDX SERIES is due to the characteristics of a mechanism the product is equipped with. If the program that is activated when the product is first powered on works properly, the front panel will automatically move into the position (initial setting angle) shown in (Fig. 2) After the Installation After the installation, perform the Initial Setup by referring to the instruction manual. Mounting and wiring this product requires skills and experience. For safety's sake, leave the mounting and wiring work to professionals. [. . . ] Do not install the unit in a spot exposed to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing. If you use the wrong screws, you could damage the unit. If the power is not turned ON ("PROTECT" is displayed), the speaker wire may have a shortcircuit or touched the chassis of the vehicle and the protection function may have been activated. Therefore, the speaker wire should be checked. If your car's ignition does not have an ACC position, connect the ignition wires to a power source that can be turned on and off with the ignition key. If you connect the ignition wire to a power source with a constant voltage supply, as with battery wires, the battery may die. If the console has a lid, make sure to install the unit so that the faceplate will not hit the lid when closing and opening. If the fuse blows, first make sure the wires aren't touching to cause a short circuit, then replace the old fuse with one with the same rating. Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals. Connect the speaker wires correctly to the terminals to which they correspond. It should be installed as horizontally as possible to allow easy reception of the GPS satellite signals. To mount the GPS antenna inside your vehicle: 1. Peel the backing off of the adhesive on the bottom of the metal plate (accessory 8). Press the metal plate (accessory 8) down firmly on your dashboard or other mounting surface. You can bend the metal plate (accessory 8) to conform to a curved surface, if necessary. Place the GPS antenna (accessory 7) on top of the metal plate (accessory 8). Installing the Talk Switch (DNX9260BT only) and the Microphone Unit 1. Check the installation position of the microphone (accessory 9) and the Talk switch (accessory 0). Remove oil and other dirt from the installation surface. Wire the microphone cable up to the unit with it secured at several positions using tape or the like. Accessory 9 Accessory 0 Accessory 7 Accessory 8 Fix a cable with a commercial item of tape. Depending on the type of car, reception of the GPS satellite signals might not be possible with an inside installation. The GPS antenna should be installed at a position that is spaced at least 12 inch (30 cm) from cellular phone or other transmitting antennas. Signals from the GPS satellite may be interfered with by these types of communication. [. . . ] Signals from the GPS satellite may be interfered with by these types of communication. Painting the GPS antenna with (metallic) paint may cause a drop in performance. Peel the release coated paper of double-face adhesive tape to fix on the place shown above. Adjust the direction of the microphone to the driver. / Install the microphone as far as possible from the cell-phone. English 9 Installation for Monitor/Player Unit Installing the Escutcheon 1. Attach accessory 6 to the unit. Attaching the monitor panel Accessory ! Accessory 6 Hold the monitor panel securely so as not to drop it accidentally. [. . . ]