User manual KENWOOD DNX7310BT

[. . . ] If you connect the ignition wire to a power source with a constant voltage supply, as with battery wires, the battery may die. If the console has a lid, make sure to install the unit so that the faceplate will not hit the lid when closing and opening. If the fuse blows, first make sure the wires aren't touching to cause a short circuit, then replace the old fuse with one with the same rating. Insulate unconnected wires with vinyl tape or other similar material. [. . . ] The unit may be damaged or fail to work if you share the - wires or ground them to any metal part in the car. When only two speakers are being connected to the system, connect the connectors either to both the front output terminals or to both the rear output terminals (do not mix front and rear). For example, if you connect the + connector of the left speaker to a front output terminal, do not connect the - connector to a rear output terminal. After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. Do not mount the unit in a place where the cooling fan of the unit are blocked. If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. Do not cut out the fuse from the ignition wire (red) and the battery wire (yellow). The power supply must be connected to the wires via the fuse. The first time you turn on the DNX7310BT, you must wait while the system acquires satellite signals for the first time. Red) to a power source that can be turned on and off with the ignition key. Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (eg, the sound may skip). It should be installed as horizontally as possible to allow easy reception of the GPS satellite signals. to mount the GPS antenna inside your vehicle: 1. Peel the backing off of the adhesive on the bottom of the metal plate (Accessory 4). Press the metal plate (Accessory 4) down firmly on your dashboard or other mounting surface. Depending on the type of car, reception of the GPS satellite signals might not be possible with an inside installation. The GPS antenna should be installed at a position that is spaced at least 12 inch (30 cm) from cellular phone or other transmitting antennas. Signals from the GPS satellite may be interfered with by these types of communication. [. . . ] Painting the GPS antenna with (metallic) paint may cause a drop in performance. Engage the catch pins on the removal tool 6 and remove the two locks on the lower level. Lower the frame and pull it forward as shown in the figure. Remove the Hex-head screw with integral washer (M4 × 8) on the back panel. [. . . ]