User manual KENWOOD DNX7330BTM

[. . . ] , it will not turn on and off along with the ignition). If you want to link the unit’s power with the ignition, connect the ignition wire to a power source that can be turned on and off with the ignition key. € Use a commercially available conversion connector if the connector does not fit in the vehicle connector. € Insulate unconnected wires with vinyl tape or other similar material. [. . . ] € After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. € Mount the unit so that the mounting angle is 30° or less. € This unit has the cooling fan (page 5) to decrease the internal temperature. Do not mount the unit in a place where the cooling fan of the unit are blocked. Blocking these openings will inhibit the cooling of the internal temperature and result in malfunction. € Do not press hard on the panel surface when installing the unit to the vehicle. Otherwise scars, damage, or failure may result. 2WARNING • If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. Acquiring GPS Signals The first time you turn on the DNX7330BTM, you must wait while the system acquires satellite signals for the first time. This process could take up to several minutes. It should be installed as horizontally as possible to allow easy reception of the GPS satellite signals. To mount the GPS antenna inside your vehicle: 1. Peel the backing off of the adhesive on the bottom of the metal plate (Accessory #). Press the metal plate (Accessory #) down firmly on your dashboard or other mounting surface. You can bend the metal plate (Accessory #) to conform to a curved surface, if necessary. Place the GPS antenna (Accessory @) on top of the metal plate (Accessory #). installing the Escutcheon For General Motors 1. Cut out accessory 7 to meet the shape of the opening of the center console. Cut out to meet the shape of the opening in the vehicle. ¤ • Depending on the type of car, reception of the GPS satellite signals might not be possible with an inside installation. € The GPS antenna should be installed at a position that is spaced at least 12 inch (30 cm) from cellular phone or other transmitting antennas. [. . . ] 31 1:34:44 PM Installation for Monitor/Player Unit Firewall or metal support Screw (M4X8) (commercially available) Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place. Self-tapping screw (commercially available) Metal mounting strap (commercially available) Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (eg, the sound may skip). Engage the catch pins on the removal tool 6 and remove the two locks on the lower level. [. . . ]