User manual KENWOOD DP-2040

[. . . ] and Canada . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 230 V only Chapter 1 For the United Kingdom Factory fitted moulded mains plug 1. The mains plug contains a fuse. For replacement, use only a 13Amp ASTA-approved (BS1362) fuse. [. . . ] For the operation of the LCD remote control unit, refer to the instruction manual provided with your receiver or LCD remote control unit. 1 Press the MODE button. MODE Chapter 5 2 Select "ALL DATA READ". DISC SKIP DOWN UP Each press switches the modes as follows: 1 MUSIC TYPE 2 DISC SEARCH 3 TITLE INPUT 4 ALL DATA READ 5 ALL INFORMATION 6 DTS DISC SKIP DISPLAY-A ALL DATA READ3 Search in progress or reading information The display flashes. DDISCCREADING3 3 Set the input. When the disc is CD-TEXT SET Chapter 6 D001:: CDATEXT3 ÷ Repeat the above procedure so that the complete disc information is read into the CD player. ÷ In the case of a non-CD-TEXT disc, the "D001:NO CD TEXT" display will appear for approx. ÷ This operation is not available during the continuous play mode. Chapter 7 To quit ALL DATA READ mode Press the 7 button. Please remove all CDs from the carousel before moving the unit. If blinking "PLEASE WAIT" is displayed when the disc door is opened, do not attempt to change the disc. Normal play (TRACK mode) Preparation ÷ Select the Player A or Player B. Normal play (TRACK mode) * The 10-key remote is not capable of controlling Player B. It should be controlled from the keyboard. Be sure to hold the ROOM B button when controlling Player B. 19 Chapter 1 Playing tracks in order from track No. 1 Use the following procedure to play a CD in the original order of tracks from track No. 1. Chapter 2 1 Select the disc. DISC SKIP DOWN UP Previous disc Next disc ÷ Each press of a button increases (or decreases) the disc number. Holding the button depressed varies the disc numbers successively. ÷ When the disc corresponds to CD-TEXT, or when the disc title has been registered, the disc title will be displayed with scrolling. Discs can be selected by the disc title. "Registration of Title" º Chapter 3 Display when disc No. ÷ All of the programmed tracks will be repeated. ÷ If a track to be played is located in the disc played on Player B, that track will be skipped. ÷ In case only one track is programmed, only that track will be repeated. Chapter 3 3 Start playback. ENTER 6 To cancel repeated playback Chapter 4 Press the REPEAT button twice. (REPEAT ON OFF) To repeat one selected disc 1 Check that the Player is in the normal play TRACK mode. ) 2 Select the disc number. DISC SKIP DOWN UP Chapter 5 Previous disc Within 8 seconds! Next disc ÷ The disc number can be selected directly by using the DISC SELECTOR and numeric buttons in place of the DISC SKIP (DOWN/UP) buttons. 3 Start playback. ENTER ÷ If the selected disc is being played on the other Player, blinking "DISCXXX BUSY!" is displayed and the disc will not be played. 6 Chapter 6 P GR E P EA T 2 ONDT 03 4 Switch REPEAT ON. REPEAT E ÷ The current status is displayed when the button is pressed once. When it is pressed while the status is displayed, the repeat ON status can be set to OFF (or vice versa). ÷ The operation is not available during the continuous play mode. To cancel repeated playback Press the REPEAT button twice. (REPEAT ON OFF) Chapter 7 For random repetition For music type or user file repetition For best selection repetition £ fi ° Playback in a random order (RANDOM mode) Use the following procedure to activate random playback which selects a track at random after every track. This feature may allow you to play CDs for long hours without getting tired of. Programming tracks in desired order (PGM mode) (Player A only) 23 The 10-key remote is not capable of controlling Player B. It should be controlled from the keyboard. Be sure to hold the ROOM B button when controlling Player B. Preparation ÷ Select the Player A or Player B. * Chapter 1 1 Check that the Player is in the normal play TRACK mode. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ ­ Reorient or relocate the receiving antenna. ­ ­ Increase the separation between the equipment and receiver. ­ ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ]