User manual KENWOOD DP-R4440

[. . . ] For replacement, use only a 13-Amp ASTA-approved (BS1362) fuse. 2. The fuse cover must be refitted when replacing the fuse in the moulded plug. 3. Do not cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or adapter, or consult your dealer. [. . . ] ÷ For use of the RDS function, stations must be memorized by RDS auto presetting. ÷ RDS stations are given priority during auto presetting. If there is memory left after presetting, the receiver continues presetting regular FM stations. AUTO One-by-one presetting (manual preset) 1 Press the "enter" key during reception. enter A MEMO Preparation section Presetting is cancelled when no operation is executed for 5 seconds or more. ÷ For memorizing of stations other than RDS stations (FM, AM), memorize the stations according to chapter "Oneby-one presetting (manual preset)". TUNED 2 Select one of the preset numbers from 1 to 40. Presetting is cancelled when no operation is executed for 5 seconds or more. volume control pure A )AUTO ST. MHz Goes off 3 Press the "enter" key again. enter ÷ Repeat steps 123 to preset other stations. ÷ If several stations are preset under the same number, the previous memory is replaced with the latest memory contents. )3 8 9 . ) ) MHz Basic section R-SE7 AUTO Select the tuning mode. auto/mono Each press alternates the mode. 1"AUTO" lit (Auto tuning) 2"AUTO" not lit (Manual tuning) FM 8 8 . ) ) MHz Application section Lights during stereo reception AUTO ST. TUNED Frequency display R-SE7 Use the manual tuning mode when reception is noisy due to weak reception. (In the manual mode, stereo broadcasts are received in monaural. ) FM 8 9 . ) ) ÷ Normally, use the AUTO (Auto tuning) mode. MHz The "TUNED" indicator lights when a station is received. About display change during tuner reception The display will change each time the DISPLAY key is pressed. Knowledge sections ÷ When a key is held depressed, preset stations will be skipped at an interval of about 0. 5 second. ÷ Preset calls also can be made by numerical input via the numeric keys on the remote control. From the next time on, this recording level is set automatically for that input even if the key is not pressed. If the key is pressed Basic section To return to the basic level . . . . . Hold the key depressed until the indicator goes off (for approx. 3 seconds). CRLS About 20 sec CRLS CRLS Application section ÷ The recording level setting completes in approx. 20 seconds, after which the deck enters the record-pause mode. ÷ If recording is started during the setting (while the CRLS indicator is blinking), distorted sound may be recorded. ÷ If a non-recorded space of more than 3 seconds is detected after the CRLS key is pressed, the recording level setting is aborted. Points for Recording from a CD or an MD For recording from a CD or an MD, playback from the music source and recording by the cassette deck can be started simultaneously (synchro recording function) when the cassette deck is set to record pause status in advance. Knowledge sections 1 Pause the CD or MD to be played. 2 Use the skip keys (4 ¢) to select the title to be recorded. (Pause will be reached at the beginning of the selected title. ) 3 Bring the cassette deck to recording pause condition. (Synchro recording will start. ) ÷ The recording is stopped when the stop key of the playback unit is pressed. Dolby HX Pro The Dolby HX Pro headroom extension system records high frequencies such as the cymbal sound clearly by controlling the bias current during recording according to the frequency composition of the sound being recorded. This system is activated automatically during recording with this unit. Playback of CD Listening in the desired sequence (program playback) Any tracks on the discs in the tray can be listened to in the desired sequence. 32 tracks) Playback of CD 31 R-SE7/DP-R4440/X-SE7 (En) Select the "CD" input. 1 Check that the CD player is in the stop mode. If it is in play mode 7 TRACK NO. Preparation section DP-R4440 1 2 7 3 8 4 9 5 10 01 0:00 6 11 2 Light the "PGM" indicator. P. MODE Lights PGM DP-R4440 TRACK NO. Basic section 01 3 Enter track Nos. in the order you want to play them. 1 Select the track. 1 2 3 4 5 6 7 8 9 PTY SEARCH +10 ÷ Up to 32 tracks can be programmed. [. . . ] 35 dB Cassette deck (X-SE7) Track . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-track, 2-channel stereo Recording system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC bias system (Frequency: 105 kHz) Heads Playback / recording head . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Erasing head . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]