User manual KENWOOD DPC-X527

[. . . ] Part names Unit (Front) Specifications Display Bass boost indicator Repeat mode indicator Program mode indicator Safety precautions Caution : Read this page carefully to ensure safe operation. Format Audio System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Compact disc digital audio system Laser . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Semiconductor laser Frequency response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 Hz to 20 kHz, ± 3 dB PHONES output level (32, 1 kHz ) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] (Digital Anti Shock Circuit) When the D. A. S. C. 12-seconds (Approx. )] or 40 seconds [Max. 48-seconds (Approx. )] portion of signals is always stored in memory. Consequently, when the unit receives an impact, playback will continue without interruption even if the signal from the light pickup is interrupted. "Wide CAPTURE" uses a method strong in regard to vibrations in the rotation direction in addition to the conventional D. A. S. C. function, so that the sound skip guard function is made even stronger. In case of difficulty What seems to be a serious trouble may sometimes be due to a simple mistake. Before calling for service, check the items shown in the following table again. (If you request servicing due to the reasons shown in the table, the service may be charged in some cases. ) Symptom Cause Remedy ÷ The HOLD switch is set to ON. Pressing a key ÷ Replace the two alkaline batter÷ The batteries are exhausted. operation or turn the ÷ The disc is placed upside down. ÷ Place the disc with the labeled unit on. ÷ Condensation has occurred in- ÷ Leave the unit for about 1 hour before re-use. ÷ The headphones are connected ÷ Insert the plug securely into the PHONES jack. ÷ The headphones are connected ÷ Insert the plug securely into the PHONES jack. to LINE OUT jack ÷ Adjust the volume on the unit or ÷ The volume is set to the remote control unit. . minimum position on the unit or remote control unit. ÷ A strong vibration that exceeds ÷ Place the unit in a place not subject to vibration. ÷ The lens should be cleaned us÷ The lens is dirty. ing a commercially available camera lens blower ÷ Clean it. ÷ The headphones are connected incompletely. ÷ A source of strong magnetism or radio wave, such as a TV set or cellular phone, is present near the unit. ÷ Insert the plug securely into the PHONES jack. [. . . ] ÷ Program mode can be canceled even if the top cover is open. J The following program sequence will be displayed. G To pause playback temporarily Blinks To stop playback Total number of tracks To turn power OFF H ÷ After stopping playback, press the 7 key again. 2 and enter it. Control tone (beep) setting The control tone generated when a key is pressed can be muted as follows. This operation should be performed in play or stop mode. I ÷ When the 6 key is pressed during playback, it pauses temporarily. ÷ Pressing the key again resumes playback. H Total playing time ÷ The total number of tracks and the total playing time of them will be displayed. ÷ Repeat steps 1 and 2 and enter the Track Nos. ÷ When 24 tracks have been programmed, "FULL" will be displayed. Auto power-OFF function If no operation key has been pressed for 2 minutes while the unit is in the stop mode, the power is turned OFF automatically to prevent battery power consumption. 3 Start playback. G When the programmed contents are to be changed further, repeat steps 2 and 3 . 1 Press and hold the B. BOOST key for more than 2 seconds. [. . . ]