User manual KENWOOD DPX-410

[. . . ] Refer to the catalog or consult your Kenwood dealer for connectable models of disc changers/ CD players. Note that any Kenwood disc changers/ CD players released in 1997 or earlier and disc changers made by other makers cannot be connected to this unit. Connecting unsupported disc changers/CD players to this unit may result in damage. Set the "O-N" Switch to the "N" position for the applicable Kenwood disc changers/ CD players. [. . . ] Push the Control knob toward up for at least 2 seconds. File Select 2 mode Select the target folder within the folders containing audio files. The folder which contains playable audio files is only displayed. 1 Enter File Select 2 mode Press the [F. SEL] button twice. Folder name display Displays the current folder name. / · When the <Display Illumination Control> (page 26) is set to OFF, the display may black out while scrolling. 2 Select the folder Push the Control knob towards right or left. Each time you push the knob, the folders containing audio files are displayed one after another. Check the name of upper level folder Push the Control knob towards up. Each time you push the knob towards up, the folder just above the current folder is displayed. Each time you push the knob towards down, the folder just below the current folder is displayed. " " is displayed while the upper level folder is displayed. 3 Determine the folder Press the Control knob. The music in the determined folder are displayed. 4 Select the music you want to listen to Operation type Operation Movement between music Push the Control knob towards right or left. Return to folder selection Press the Control knob for at least 1 second. step 5 Play the selected music Press the Control knob. Scrolling the file/folder name display Push the Control knob toward up for at least 2 seconds. Cancelling File Select 2 Press the [F. SEL] button. English | 23 Menu system Control knob MENU Menu display SRC NEWS indicator RDS indicator Menu System Setting beep sound during operation, etc. Display "DISP ON" "DISP OFF" Setting Keeps the display on. Turns off the display when you perform no operation for 5 seconds. Manual Clock Adjustment / · You can do this adjustment when the <Synchronize Clock> (page 26) is set as OFF. 1 Select Clock Adjustment mode Push the Control knob towards up or down. Select the "CLK ADJ" display. 2 Enter Clock Adjust mode Press the Control knob for at least 1 second. The clock display blinks. / · Set the Display Illumination Control when the <Demonstration mode Setting> (page 31) is set to OFF. · When the display is off, pressing any key will turn on the display. · When the display is off, you cannot perform any operation except for the following: · Volume · Attenuator · Selecting the source · Ejecting the disc · Turning off the power · USB remove mode · During function control, such as the Menu System, the display stays on. 3 Adjust the hours Push the Control knob towards up or down. Adjust the minutes Push the Control knob towards right or left. 4 Exit Clock adjustment mode Press the [MENU] button. In Standby mode Synchronize Clock Synchronizing the RDS station time data and this unit's clock. Display "SYNC ON" "SYNC OFF" Setting Synchronizes the time. Adjust the time manually. In Standby mode Dimmer Dimming this unit's display automatically when the vehicle light switch is turned ON. Display "DIM AUTO" "DIM OFF" Setting The display dims. The display doesn't dim. / · It takes 3 to 4 minutes to synchronize the clock. In Standby mode Switching preout Alternating the preout between the rear and subwoofer. [. . . ] And then press the reset button on the unit. If the "E-99" code does not disappear, consult your nearest service center. Discs are being exchanged in the Disc changer. The unit is reading the data on the disc. [. . . ]