User manual KENWOOD DPX500BT

[. . . ] DPX500BT DPX300U DUAL DIN SIZED CD RECEIVER Quick Start Guide RECEPTEUR CD FORMAT DUAL DIN Guide de démarrage rapide RECEPTOR DUAL DE CD TAMAÑO DIN Guía de inicio rápido Take the time to read through this instruction manual. Familiarity with installation and operation procedures will help you obtain the best performance from your new Dual DIN sized CD receiver. For your records Record the serial number, found on the back of the unit, in the spaces designated on the warranty card, and in the space provided below. Refer to the model and serial numbers whenever you call upon your Kenwood dealer for information or service on the product. [. . . ] For example, if you connect the + connector of the left speaker to a front output terminal, do not connect the connector to a rear output terminal. € After the installing the unit, check whether the brake lamps, blinkers, wipers, etc. € Mount the unit so that the mounting angle is 30° or less. To prevent a short circuit, remove the key from the ignition and disconnect the - battery. Make the proper input and output wire connections for each unit. Connect the speaker wires of the wiring harness. Connect the wiring harness wires in the following order: ground, battery, ignition. Connect the wiring harness connector to the unit. Indd 8 13/04/26 15:4 DPX500BT only • Reception may become poor if there are metal objects near the Bluetooth antenna. (DPX500BT only) Installing the Microphone unit Check the installation position of the microphone (Accessory 5). Using wrong screws might damage the unit. Indd 10 13/04/26 15:4 Removing the Unit Removing the trim plate 1 Engage the catch pins on the extraction key (Accessory 4) and remove the two locks on the lower level. Lower the frame and pull it forward as shown in the figure. Accessory 4 Removing the Unit 1 2 Remove the trim plate by referring to the removal procedure in the section <Removing the trim plate>. Insert the two extraction keys (Accessory 4) deeply into the slots on each side, as shown. Accessory 4 Lock Catch 3 Lower the extraction key toward the bottom, and ⁄ • The frame can be removed from the top side in the same manner. Pull out the unit halfway while pressing towards the inside. 2 When the lower level is removed, remove the upper two locations. ¤ • Be careful to avoid injury from the catch pins on the extraction key. 4 Pull the unit all the way out with your hands, being careful not to drop it. english | 11 B59-2162-10_01_13-2DIN_QSG_K_en. Indd 11 13/04/26 15:4 Connecting Wires to Terminals Microphone input (DPX500BT only) Microphone (Accessory5) R L Antenna Cord FM/AM antenna input White To front left speaker To front right speaker To rear left speaker To rear right speaker White/Black Gray Gray/Black Green Green/Black Purple Purple/Black Ignition key switch Car fuse box ACC Car fuse box (Main fuse) Red (Ignition wire) Yellow (Battery wire) Black (Ground wire) · (To car chassis) + – Battery 12 | Quick Start Guide B59-2162-10_01_13-2DIN_QSG_K_en. [. . . ] € BlackBerry®, RIM®, Research In Motion® and related trademarks, names and logos are the property of Research In Motion Limited and are registered and/or used in the U. Used under license from Research In Motion Limited. Indb 43 13/06/20 9:2 2CAUTION Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. In compliance with Federal Regulations, following are reproductions of labels on, or inside the product relating to laser product safety. [. . . ]