User manual KENWOOD ES020 KMIX BLANC

[. . . ] Wash the parts: see ‘cleaning’. Flush the machine through with clean water: see ‘before making coffee for the first time’. Before making coffee for the first time 1 Make sure the variable steam knob is closed by turning clockwise (don’t overtighten). 2 Lift the lid, then lift out the tank and fill with cold water. [. . . ] Important Never remove the filter holder while the coffee or steam function is selected – steam could shoot out and burn you. 4 cleaning steam nozzle Prior to cleaning the steam nozzle allow some hot water to flow out of the nozzle to assist with the cleaning operation. This should be carried out immediately after having dispensed steam. Here’s how:Ensure there is water in the tank and that there is a jug under the steam nozzle. Open the steam knob by turning in an anti-clockwise direction. Press the coffee button and operate for approximately 10 seconds to allow hot water to pass through the nozzle. Switch off the coffee button then close the variable steam knob by turning clockwise. Press the on/off button to switch off the machine. Before further cleaning, unplug and let everything cool. Don’t wash parts in the dishwasher. To make coffee using filter pods Important If the filter for one cup is used after ground coffee has been used, it is necessary to clear any ground coffee from around the coffee outlet. This is necessary to avoid water leakages from the filter holder and to ensure optimum performance. 1 Pre heat the machine as described on page 2, fitting the small filter in the filter holder. 3 Press the pod towards the lower part of the filter, making sure that the paper flaps adhere to the inner part of the filter. 4 The pod needs to be well centred and placed firmly in the filter. 5 Fit the filter holder into the coffee outlet and turn to the right until it locks into position ᕡ. 6 Follow the points ‘to make espresso’. Note – use pods that conform to the ESE standard. — Always follow the instructions on the package of the pods for the correct positioning of the pods in the filter 1 2 3 4 5 6 ● ● ● steam nozzle 1 Unscrew the nozzle by turning clockwise, then wash thoroughly. Check that the 3 holes indicated are not blocked Ƹ. 3 Screw the nozzle back onto the delivery tube. Press the steam button and the red steam indicator light will flash. [. . . ] — The green coffee ready indicator light ● Wait until the green coffee indicator light stops flashing before pressing the coffee button. Was not glowing when the coffee button was pressed. — The tank is incorrectly fitted and the ● Press the tank lightly so as to open the valve at the bottom. — The ground coffee has not been ● Press the coffee more firmly. [. . . ]