User manual KENWOOD HM-233

[. . . ] MICRO HI-FI COMPONENT SYSTEM Thank you for purchasing this KENWOOD product. To obtain the best performance from this product, please read this manual carefully. It will guide you in operating your KENWOOD product. HM-233 Micro HI-FI Component System consisting of RD-M23 (main unit) and LS-M23 (speaker system). HM-233 INSTRUCTION MANUAL KENWOOD CORPORATION B60-5125-08 00 CH (T) 0105 Important Safeguards Please read all of the safety and operating instructions before operating this appliance. [. . . ] Consult your dealer. External FM aerial 15 m (49 feet) External AM aerial AM loop aerial Incorrect 7. 5 m (25 feet) Earth rod Connecting the AC power lead After checking all the connections have been made correctly, connect the AC power lead to the AC power input socket, then plug the AC power lead of this unit into the wall socket. Notes: When an external FM aerial is used, disconnect the supplied FM aerial wire from the FM 75 OHMS socket. When using an external AM aerial, be sure to keep the wire of the AM loop aerial connected. Notes: Unplug the unit if it will not be used for a prolonged period of time. Never use a power lead other than the one supplied. Otherwise, a malfunction or an accident may occur. 11 - System Connections - Remote Control Battery installation 1 Remove the battery cover. 2 Insert the batteries according to the direction indicated in the battery compartment. When inserting or removing the batteries, push them towards the nals. battery termi- Test of the remote control Face the remote control directly to the remote sensor on the unit. The remote control can be used within the range shown below: Press the ON/STANDBY button. Now, you can enjoy the music. 3 Replace the cover. Remote sensor Preparation for Use - Remote Control - Precautions for battery use: Replace all old batteries with new ones at the same time. Remove the batteries if the unit will not be used for long periods of time. This will prevent potential damage due to battery leakage. 0. 2 m - 6 m (8" - 20') Caution: Do not use rechargeable batteries (nickel-cadmium battery, etc. ). Installing the batteries incorrectly may cause the unit to malfunction. Notes concerning use: Replace the batteries if the operating distance is reduced or if the operation becomes erratic. Purchase 2 "AAA" size batteries (UM-4, R03, HP-16 or similar). Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth. Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit. Keep the remote control away from moisture, heat, shock, and vibrations. 12 General Control To turn the power on Press the ON/STANDBY button to turn the power on. To set the unit to stand-by mode: Press the ON/STANDBY button again. To change the display brightness (2 levels) You can switch the display brightness by pressing the DIMMER button on the remote control. Dimmed Brightened Basic Operation Opening and closing the CD compartment The CD compartment cover is motorised. When the power is turned on, you can open or close the CD compartment cover by pressing the OPEN/CLOSE button. Caution: Do not stop or move the CD compartment cover manually. Be careful not to jam your fingers in the CD compartment cover. 13 - General Control - Sound Control Adjusting the volume Press the VOLUME decreasing. button to increase the volume and the VOLUME button for MIN 1 2 . . . . . 28 29 MAX Adjusting the bass Main unit operation: Basic Operation 1 2 Press the BASS/TREBLE button until "BASS" appears on the display. Within 5 seconds, press the VOLUME ( or ) button to adjust the bass. Remote control operation: - Sound Control - Press the BASS ( or ) button to adjust the bass. -5 . . . 0 . . . 5 Adjusting the treble Main unit operation: 1 2 Press the BASS/TREBLE button until "TRE" appears on the display. Within 5 seconds, press the VOLUME ( or ) button to adjust the treble. Remote control operation: Press the TREBLE ( or ) button to adjust the treble. -5 . . . 0 . . . 5 14 Setting the Clock 3 Within 1 minute, press the PRESET ( or ) button to adjust the hour and then press the MEMORY button. When the 12-hour display is selected, "AM" will change automatically to "PM". 4 Within 1 minute, press the PRESET ( or ) button to adjust the minutes and then press the MEMORY button. To confirm the time display when the power is on: This may be operated only with the remote control. In this example, the clock is set for the 24-hour (0:00) display. [. . . ] (Refer to step 3 under "If trouble occurs" on page 26. ) No sound is heard. Is the volume level set to "0"?Are the speaker wires disconnected? Remote control Symptom The remote control does not operate. Possible cause Is the battery polarity respected? [. . . ]