User manual KENWOOD KAC-7406

[. . . ] € When replacing a fuse, only use a new one with the prescribed rating. Using a fuse with the wrong rating may cause your unit to malfunction. € To prevent a short circuit when replacing a fuse, first disconnect the wiring harness. NOTE • If you experience problems during installation, consult your Kenwood dealer. [. . . ] Remove the ignition key and disconnect the negative · Terminal of the battery to prevent short circuits. Set the unit according to the intended usage. Connect the input and output wires of the units. Connect the power wire, power control wire and grounding wire following this order. Install the installation fittings in the unit. ATTENTION 7 Procedimiento de instalación 1 Parts included Pieces comprises Partes incluidas • Do not install in the below locations; (Unstable location, In a location that interferes with driving, In a location that gets wet, In a dusty location, In a place that gets hot, In a place that gets direct sunlight, In a location that gets hit by hot air) • Do not install the unit under the carpet. Otherwise heat build-up occurs and the unit may be damaged. € Install this unit in a location which allows heat to easily dissipate. Once installed, do not place any object on top of the unit. € The surface temperature of the amplifier will become hot during use. Install the amplifier in a place where people, resins, and other substances that are sensitive to heat will not come into contact with it. € When making a hole under a seat, inside the trunk, or somewhere else in the vehicle, check that there is nothing hazardous on the opposite side such as a gasoline tank, brake pipe, or wiring harness, and be careful not to cause scratches or other damage. € Do not install near the dashboard, rear tray, or air bag safety parts. € The installation to the vehicle should securely fasten the unit to a place in which it will not obstruct driving. If the unit comes off due to a shock and hits a person or safety part, it may cause injury or an accident. € After installing the unit, check to make sure that electrical equipment such as the brake lamps, turn signal lamps and windshield wipers operate normally. PRECAUCIÓN Remove the ignition key and disconnect the negative · Terminal of the battery to prevent short circuits. WARNING WARNING Particular attention must be given to making good electrical contact at the amplifier-output and speaker terminals. Poor or loose connections can cause sparking or burning at the terminals because of the very high power that the amplifier can deliver. € If the fuse blows, check wires for shorts, then replace the PRECAUCIÓN fuse with one of the same rating. Old electrical and electronic equipment should be recycled at a facility capable of handling these items and their waste byproducts. Contact your local authority for details in locating a recycle facility nearest to you. [. . . ] Ch) This switch allow filtering of the speaker output signals. € HPF (High-Pass Filter) position: NOTE If you can’t find the specified capacity fuse at your store etc. , Only frequencies of 80 Hz or higher are output. ) The entire bandwidth is output without filtering. [. . . ]