User manual KENWOOD KAC-8405

[. . . ] When replacing a fuse, only use a new one with the prescribed rating. Using a fuse with the wrong rating may cause your unit to malfunction. To prevent a short circuit when replacing a fuse, first disconnect the wiring harness. nOTE · If you experience problems during installation, consult your Kenwood dealer. [. . . ] Do not install in the below locations; (Unstable location, In a location that interferes with driving, In a location that gets wet, In a 259 mm dusty location, In a place that gets hot, In a place that gets direct sunlight, In a location that gets hit by hot air) M4 × 8 mm 3 Parts included/Pieces comprises/Partes incluidas · Do not install the unit under the carpet. Hexagon socket head cap screw Otherwise heat build-up occurs and the unit Vis d'assemblage à six pans creux may be damaged. cooling fan · Install this unit in a location which allows heat to Tornillo de cabeza hexagonal Ventilateur de easily dissipate. Refroidissement Once installed, do not place any object on top Ventilador de of the unit. refrigeración · The surface temperature of the amplifier will 1 Parts included become hot during use. Install the amplifier in a Pieces comprises place where people, resins, and other substances Partes incluidas that are sensitive to heat will not come into contact with it. Do not mount the unit in a place Cubierta de adorno where the cooling fan and ducts of the unit are blocked. When making a hole under a seat, inside the trunk, or somewhere else in the vehicle, check that there is nothing hazardous on the opposite side such as a gasoline tank, brake pipe, or wiring harness, and be careful not to cause scratches or other damage. Do not install near the dashboard, rear tray, or air bag safety parts. The installation to the vehicle should securely fasten the unit to a place in which it will not obstruct driving. If the unit comes off due to a shock and hits a person or safety part, it may cause injury or an accident. After installing the unit, check to make sure that electrical equipment such as the brake lamps, turn signal lamps and windshield wipers operate Installation board, etc. If sound is not output normally, immediately turn power Cable de control de alimentación flojas pueden causar chispas o quemaduras en off and check connections. los terminales debido a la potencia muy alta que · Be sure to turn the power off before changing the setting puede suministrar el amplificador. If the fuse blows, check wires for shorts, then replace the PRECAUCIÓN fuse with one of the same rating. After installation, check that the brake lamps, turn signal · Particular attention must be given to making good electrical contact at the amplifier-output and speaker terminals. Poor or loose connections can cause sparking or burning at the terminals because of the very high power that the amplifier can deliver. Front left speaker Haut-parleur avant gauche Altavoz delantero izquierdo Front right speaker Haut-parleur avant droit Altavoz delantero derecho Rear left speaker Haut-parleur arrière gauche Altavoz trasero izquierdo Rear right speaker Haut-parleur arrière droit Altavoz trasero derecho Products with the symbol (crossed-out wheeled bin) cannot be disposed as household waste. Old electrical and electronic equipment should be recycled at a facility capable of handling these items and their waste byproducts. contact your local authority for details in locating a recycle facility nearest to you. Proper recycling and waste disposal will help conserve resources whilst preventing detrimental effects on our health and the environment. This Product is not installed by the manufacturer of a vehicle on the production line, nor by the professional importer of a vehicle into an EU Member State. [. . . ] MONO (Lch) position: Amplifies the signal input from the left side only. Set to this position and make bridged connections to use as a highpower monaural amplifier. Ch) Set this control according to the pre-output level of the center unit connected with this unit. For the pre-output level, refer to the <Specifications> in the instruction manual of the center unit. [. . . ]