User manual KENWOOD KAC-M527

[. . . ] If the problem or your question is not handled to your satisfaction, please contact our Customer Relations Department at the address listed below: KENWOOD ELECTRONICS CANADA INC. (e) Defects resulting from disaster, accident, abuse, misuse, lightning, power surges, neglect or lack of periodic maintenance, unauthorized modification or failure to follow instructions in the owner’s manual. (f) Defects or damage as a result of repairs performed by a person or party not authorized by KENWOOD. (g) Defects resulting from the use of parts or devices that do not conform to KENWOOD specifications. [. . . ] Familiarity with installation and operation procedures will help you obtain the best performance from your new power amplifier. Attention: This card and receipt (or invoice) are necessary to purchase a new panel in case of theft or damage. For your records Record the serial number, found on the back of the unit, in the spaces designated on the warranty card, and in the space provided below. Refer to the model and serial numbers whenever you call upon your Kenwood dealer for information or service on the product. Military exchange service overseas may be serviced under warranty in the continental U. Safety precautions LIMITATION OF IMPLIED WARRANTIES Any and all implied warranties, including warranties of merchantability and fitness for a particular purpose, shall be limited in duration to the length of this warranty. Précautions de sécurité Protection function The protection function is activated in the following situations: This unit is equipped with a protection function for protecting this unit and your speakers from various accidents or problems that can occur. When the protection function is triggered, the amplifier stops operating. € When the unit malfunctions and a DC signal is sent to the speaker output. € When the internal temperature is high and unit won’t operate. € When detects a low impedance at the speaker connections. Also avoid places with too much dust or the possibility of water splashing. € When replacing a fuse, only use a new one with the prescribed rating. Using a fuse with the wrong rating may cause your unit to malfunction. € To prevent a short circuit when replacing a fuse, first disconnect the wiring harness. NOTE • If you experience problems during installation, consult your Kenwood dealer. € If the unit does not seem to be working right, consult your Kenwood dealer. Box 22745, 2201 East Dominguez Street, Long Beach, California 90801-5745 Tel: (310) 639-5300 • If a buzzing noise is heard from the speakers when the engine is running, connect a line noise filter (optional) to each of the battery wire. € Do not allow the wire to directly contact the edge of the iron plate by using Grommets. € Connect the ground wire to a metal part of the car chassis that acts as an electrical ground passing electricity to the battery‘s negative · terminal. Do not turn the power on if the ground wire is not connected. € Be sure to install a protective fuse in the power cord near the battery. [. . . ] Specifications Specifications subject to change without notice. 45 W × 4 Signal to noise ratio (Reference: 1Watt into 4 ohms) . (grosor: 15 mm o más) 3 Parts included Pieces comprises Partes incluidas 350 mm (13-3/4) Connection / Raccordements / Conexiones Remove the ignition key and disconnect the negative · Terminal of the battery to prevent short circuits. WARNING WARNING ADVERTENCIA Spécifications A-4 B-3 Fuse (15 A) NOTE If you can’t find the specified capacity fuse at your store etc. [. . . ]