User manual KENWOOD KAF-S500

[. . . ] KAF-S500 INSTRUCTION MANUAL KENWOOD CORPORATION About the supplied remote control Compared to standard remote controls, the remote control supplied with this amplifier has several operation modes. These modes enable the remote control to control other audio/video components. In order to effectively use the remote control, it is important to read the operating instructions and obtain a proper understanding of the remote control and how to switch its operation modes (etc. ). Using the remote control without completely understanding its design and how to switch the operation modes may result in incorrect operations. DIGITAL SURROUND AMPLIFIER B60-5392-08 00 CH (Y) KW 0304 名称未設定-8 1 03. 8. 24, 10:53 PM Before applying the power Units are designed for operation as follows. [. . . ] Use the TRIM%/fi keys to adjust the volume level of the test tone output from the speaker channel to be adjusted. For AUTO selection, the first test tone is heard from the front left speaker for 3 seconds. The next test tone is heard from the speakers in the following sequence for 3 seconds each. If you selected other than “LRG” as the center speaker setting, 1 SURR ON 2 SURR OFF : Surround speaker setting mode to the amplifier is ON. : Surround speaker setting mode to the amplifier is OFF. • When the setting “SURR OFF” is selected, by pressing the SET UP key in step 9 the procedure skips to step @. But if “SW OFF” is selected, press the SET UP key to skip to step 5. 9 Press the SET UP key again to accept the setting. • The back surround speaker setting indication “BS” appears. 0 Use the TRIM%/fi keys to select appropriate surround back speaker setting. If you selected “LRG” as the surround speaker setting, 1 BS NML 2 BS LRG 3 BS OFF : : : Average size back surround speaker is connected to the amplifier. Large back surround speaker is connected to the amplifier. Back surround speaker setting mode to the amplifier is OFF. DIGITAL ST. AUTO L SW C LS R BS RS The channel indication blinks while the test tone is being output. DOLBY DEX NEO:6 DOLBY PLII DTS -ES AAC DISCRETE MATRIX 6. 1 ACTIVE EQ. DSP TS MUTE L LFE C R SW DOLBY DEX NEO:6 DOLBY PLII DTS -ES AAC DISCRETE MATRIX 6. 1 ACTIVE EQ. AUTO L LFE C R SW LS S BS RS LS S BS RS If you selected “NML” as the surround speaker setting, 1 BS NML 2 BS OFF : Back surround speaker setting mode to the amplifier is ON. : Back surround speaker setting mode to the amplifier is OFF. • If you change the volume level settings for the speakers while listening to music, the settings referred to on this page are also changed. • If the speaker setting selects are OFF, the speaker level settings are reset. For “MANUAL” selection, press the FRONT, CENTER, REAR or SW keys to select the speaker channel and then adjust the volume level by pressing TRIM%/fi keys. 16 EN 名称未設定-10 16 03. 8. 24, 10:55 PM Preparing for surround sound • Press the FRONT key each time to select Front L or Front R channel. • Press the CENTER or SW key to select center or subwoofer channel. • Press the REAR key to select surround channel. And use the REAR key for the following displays. • The test tone is turned off and return to the main setup displays. 6 Input the distance to the speakers. 1 Measure the distance from the listening position to each of the speakers. Jot down the distance to each of the speakers. Distance to Front left speaker (L) : ____ meters Distance to Center speaker (C) : ____ meters Distance to Front right speaker (R) : ____ meters Distance to Surround right (RS) : ____ meters Distance to Back Surround (BS) : ____ meters Distance to Surround left (LS) : ____ meters Distance to Subwoofer (SW) : ____ meters 2 Press theTRIM%/fi keys to select the “DISTANCE” on setup displays and press the SETUP key again. [. . . ] 8 Ω Frequency Response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 140 Hz ~ 40, 000 Hz Sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 78 dB Crossover Frequency . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 kHz Rated Input Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]