User manual KENWOOD KCA-IP200

[. . . ] · Check that no metal objects (coins, tools, etc. ) are left inside the unit to avoid short circuits. · If you smell or see smoke, turn the power off immediately and consult your Kenwood dealer. · Do not touch the liquid crystal fluid if the LCD is damaged or broken due to shock. The liquid crystal fluid may be dangerous to your health or even fatal. [. . . ] 1 Using the number buttons on the remote control, enter the number of the disc that you want to listen to. The selected disc number blinks in the display for 10 seconds. If you make no further input in the 10-second period, the number entry mode will automatically be cancelled. NOTE Disc Repeat Function of remote Repeat playing the disc currently being listened to. To repeat disc : Press the DISC REPEAT button. The D. REP indicator will appear on the display and the Disc repeat function will turn on. To cancell : Press the DISC REPEAT button. The D. REP indicator disappears and the Disc repeat function is cancelled. NOTE · Input "0" to select disc #10. · If you enter more than two numbers all at once, a search will be made only of the last number entered. 2 Press either the + or ­ button whilst the number inputted is When disc play stops, Disc repeat is cancelled. blinking. The disc specified in step 1 starts playing. Cancelling Direct Disc Search During Its Operation : Press the 38 button. Track Repeat Repeat playing the track currently being listened to. To repeat track : Press the REP (REPEAT. . . Remote) button. The REP indicator will appear on the display and the Track repeat function will turn on. Before using this function, cancell the other functions. This function cannot be used while loading a disc (while the play indicator is blinking). If a disc with a high recording level is used, the sound may distort even if the prevention of distortion function is set to "2" (ON). In this case, reduce the modulation level. To cancell : Hold down the RDM button on the display unit for more than three seconds. The LEVEL indicator will go off and the modulation level change will take effect. The control mode is automatically cancelled if you do nothing for 15 seconds. 2 To change the modulation level Press the 4 or ¢ button on the display unit. Each time the 4 or ¢ button is pressed, the modulation level changes in the range from 1 to 4. As the number increases, the modulation level increases. The initial setting is 2. -- 10 -- Accessories External view . . . . . . . . . Number of items Installation Procedure 1. To prevent a short circuit, remove the key from the ignition and disconnect the - battery. Make the proper input and output wire connections for each unit. [. . . ] Change the Modulation level / Dynamic control setting. (Page 10) Try playing another disc. If the sound is good, the fault was with the original disc. Press the Reset button of the display unit. See "Connecting Wires to Terminals" . (Page 12) Turn off Random Play / Magazine Random Play. Nothing appears on the display. The control output of the display unit is not connected properly. [. . . ]