User manual KENWOOD KDC-122

[. . . ] · If the unit starts to emit smoke or strange smells, turn off the power immediately and consult your Kenwood dealer. · Make sure not to get your fingers caught between the faceplate and the unit. · Be careful not to drop the unit or subject it to strong shock. The unit may break or crack because it contains glass parts. [. . . ] When the function is on, the TI indicator is turned on. When none is being received, the TI indicator will blink on and off. When a traffic information station is being received, the TI indicator will turn on. When a traffic bulletin begins to be broadcast, "TRAFFIC" will be displayed, and reception will begin at the preset volume. If you are listening to a tape or disc when a traffic bulletin begins, they will automatically be turned off. When the bulletin ends or poor reception is experienced, the tape or disc will begin playing again. NOTE 1 Tune into the station for which you want to set the volume. 2 Adjust the volume to the desired level. 3 Hold down the TI VOL ADJ button for two seconds or more. The volume level blinks once in the display to indicate that the data has been stored. Future traffic information/news broadcasts are heard at the preset level. NOTE Pressing the TI button whilst in the MW/LW band automatically switches reception to the FM band. However, the MW/LW band is not returned to when the TI button is pressed again. Switching to a Different Traffic Information Station: Use the 4 / ¢ buttons to make an auto seek of the TI stations in a certain band. NOTE · The volume cannot be lowered by this function during tuner reception. The CD stops playing and ejects from the slot. 2CAUTION SCAN RDM REP CLK 4 AM · Do not attempt to insert a CD into the slot if another one is already there. · The unit can only play 12-cm (5-inch) CDs. If you insert an 8-cm (3-inch) CD, it will get stuck inside and can cause the unit to malfunction. NOTE When you load a CD and eject it right away, the next time you try to insert the CD may not load. In such a situation, take the CD out for a moment and then reinsert it. 3 indicator Track number Track time Clock display Switching to the Clock display: Each time you press the CLK button, the display switches between the Track time and Clock. CD-IN indicator -- 17 -- CD player features English Fast Forwarding and Reversing Disc Play Fast Forwarding Disc Play: Hold down on the ¢ button. Release your finger to play the disc at that point. Reversing Disc Play: Hold down on the 4 button. Release your finger to play the disc at the point. Track Repeat Repeat playing the current track. Turning Repeat Play Function On/Off: Press the REP button to switch the repeat play function on and off. "REP ON" is displayed when repeat play is turned on. The track number currently being heard blinks in the display. NOTE The repeat play function is cancelled when you stop playing the disc. Track Search Search forwards or backwards through the tracks on the disc until you reach the one that you want to listen to. Making a Reverse Track Search: Press the 4 button to display the desired track number. Press once to search back to the beginning of the current track, twice to search back to the beginning of the previous track, and so forth. [. . . ] Before calling service, first check the following table for possible problems. PROBLEM The power does not turn on. POSSIBLE CAUSE The fuse has blown. No ACC position on vehicle ignition. SOLUTION After checking for short circuits in the cables, replace the fuse with one having the same rating. Connect the same cable to the ignition as the battery cable. Reset the fader and/or balance settings. [. . . ]