User manual KENWOOD KDC-148

[. . . ] KDC-148 KDC-108 KDC-MP148CR CAUTION Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. In compliance with Federal Regulations, following are reproductions of labels on, or inside the product relating to laser product safety. Location : Top Panel FCC WARNING CD-RECEIVER INSTRUCTION MANUAL AMPLI-TUNER LECTEUR DE CD MODE D’EMPLOI REPRODUCTOR DE DISCOS COMPACTOS RECEPTOR DE FM/AM MANUAL DE INSTRUCCIONES This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. [. . . ] Setting the demonstration mode 1 Press the volume knob to enter [FUNCTION]. 2 Turn the volume knob to select [DEMO MODE], then press to enter. 3 Turn the volume knob to select [ON] or [OFF]. If [ON] is selected, display demonstration starts if no operation is done for about 20 seconds. Initial settings before operations 1 Press SRC to enter [STANDBY] mode. 2 Press the volume knob to enter [FUNCTION] mode. 3 Turn the volume knob to select [INITIAL SET], then press to enter. 4 Turn the volume knob to make a selection, then press to confirm. Item Selectable setting (Preset: *) PRESET TYPE NORM *: Memorizes one station for each preset button in each band (FM1/ FM2/ FM3/ AM). ; MIX: Memorizes one station for each preset button regardless of the selected band (FM1/ FM2/ FM3/ AM). kEY BEEP ON */ OFF: Activates/deactivates the keypress tone. BUILTIN AUX ON1 *: Outputs sound of the connected external component when “AUX” is selected as the source. ; ON2: Outputs sound from the connected external component when “AUX” is selected as the source. When you turn on the power, the sound attenuates (to prevent noise when no external component is connected). Turn the volume knob clockwise to return to the previous volume level. ; OFF: Disables “AUX” in source selection. CD READ 1 *: Automatically distinguishes between audio file disc and music CD. SWITCH PRE REAR */ SUB-W: Selects whether rear speakers or a subwoofer are connected to the line out terminals on the rear of the unit (through an external amplifier). SP SELECT OFF */ 5/4/ 6 × 9/6/ OEM: Selects the speaker size for optimum performance. Indd 6 7/30/10 5:51:19 PM Hold for about 2 seconds to memorize the current station. Adjust [SETTINGS] mode settings While listening to the radio. 1 Press the volume knob to enter [FUNCTION] mode. [. . . ] Basic procedure 1 Remove the key from the ignition switch, then disconnect the · \ “Wiring connection” (page 13) 3 Install the unit to your car. \ “Installing the unit” (page 14) 4 Reconnect the · (page 3) Warning The unit can only be installed in a car with a 12 V DC power supply, negative ground. If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. [. . . ]