User manual KENWOOD KDC-2027SG ANNEXE 503

[. . . ] To prevent injury and/or fire, take the following precautions: Insert the unit all the way until it is fully locked in place. Otherwise it may fly out of place during collisions and other jolts. When extending the ignition, battery or ground wires, make sure to use automotivegrade wires or other wires with an area of 0. To prevent short circuits, never put or leave any metallic objects (e. [. . . ] select the Audio item for adjustment Press the [FM] or [AM] button. Each time the button is pressed the items that can be adjusted switch as shown below. adjust the Audio item Press the [4] or [¢] button. Adjustment Item Display Bass level "BAS" Middle level "MID" Treble level "TRE" Balance "BL" Fader "FD" Exit Audio Control mode Press the [AUD] button. You can recall the best sound setting preset for different types of the music. Each time the button is pressed the sound setting switches. Each setting value is changed with the <Speaker setting> (page 8). First, select the speaker type with the Speaker setting. When the System Q setting is changed, the Bass, Middle, and Treble set in audio control replace the System Q values. Enter clock adjustment mode Press the [ADJ] button for at least 2 seconds. A red indicator will blink on the unit after the faceplate is removed, warning potential thieves. Turn the power OFF Press the [SRC] button for at least 1 second. set the DSI While pressing the [1] and [3] button , press the [SRC] button. Each time the step 1 and 2 operation is done the DSI turns ON or OFF. Each time the button is pressed the clock display turns ON or OFF. The faceplate of the unit can be detached and taken with you, helping to deter theft. The faceplate is a precision piece of equipment and can be damaged by shocks or jolts. For that reason, keep the faceplate in its special storage case while detached. Do not expose the faceplate or its storage case to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing. The faceplate is locked in place, allowing you to use the unit. Noise can be reduced when stereo broadcasts are received as monaural. [. . . ] Make sure to make the proper connections to prevent damage to the unit. the default connection for the wiring harness is described in 1 below. If the ISO connector pins are set as described in 2 or 3, make the connection as illustrated. Please be sure to reconnect the cable as shown 2 below to 1 (Default setting) The A-7 pin (red) of the vehicle's ISO connector is linked with the ignition, and the A-4 pin (yellow) is connected to the constant power supply. [. . . ]