User manual KENWOOD KDC-348U

[. . . ] KDC-BT648U KDC-X695 KDC-X395 KDC-348U CD-RECEIVER INSTRUCTION MANUAL AMPLI-TUNER LECTEUR DE CD MODE D’EMPLOI REPRODUCTOR DE DISCOS COMPACTOS RECEPTOR DE FM/AM MANUAL DE INSTRUCCIONES Take the time to read through this instruction manual. Familiarity with installation and operation procedures will help you obtain the best performance from your new CD-receiver. For your records Record the serial number, found on the back of the unit, in the spaces designated on the warranty card, and in the space provided below. Refer to the model and serial numbers whenever you call upon your Kenwood dealer for information or service on the product. [. . . ] KDC-X395 / KDC-348U Press and hold the volume knob to enter Bluetooth mode. 2 Turn the volume knob to select [SETTINGS], then press to enter. 3 Turn the volume knob to select [PAIRING], then press to enter. 4 Turn the volume knob to select [S-DVC SELECT], then press to enter. 5 Turn the volume knob to select a device name , press to confirm. 6 Go through the procedure step 4 of <Registering from this unit> and complete the registration (pairing). – If the device name is not in the list, select “OTHER PHONE”. 3 Turn the volume knob to select [PAIRING], then press to enter. 4 Turn the volume knob to select [PHONE SELECT] or [AUDIO SELECT], then press to enter. 5 Turn the volume knob to select a Bluetooth device name. 6 Press the volume knob to set up the Bluetooth device. – If a cell-phone is already selected, deselect it, and then select a different one. KDC-X395 / KDC-348U Press and hold the volume knob to enter Bluetooth mode. 2 Turn the volume knob to select [SETTINGS], then press to enter. 3 Turn the volume knob to select [VOICE TAG], then press to enter. 4 Turn the volume knob to select [PB NAME EDIT], then press to enter. 5 Search for the Phone Book name to register Select the name to register with reference to 5 in <Calling a Number in the Phone Book> (page 16). If a voice tag has already been registered for a name, “*” is displayed before the name. 6 Turn the volume knob to select [PB NAME REG], then press to enter. Selecting the Bluetooth Device 1 KDC-BT648U / KDC-X695 Press to enter Bluetooth mode. Turn the volume knob to select “YES”, then press to confirm. When a beep is heard, say a voice tag within 2 seconds. [. . . ] 5 kHz ±8 dB Preout level / load (CD): KDC-X695/KDC-X395: 4, 000 mV/ 10 kΩ KDC-BT648U/KDC-348U: 2, 500 mV/ 10 kΩ Preout impedance: ≤ 600 Ω Auxiliary input section Frequency response (±3 dB): 20 Hz — 20 kHz Input maximum voltage: 1, 200 mV Input impedance: 10 kΩ General Operating voltage: KDC-BT648U/KDC-X695: (10. – “Made for iPod” and “Made for iPhone” mean that an electronic accessory has been designed to connect specifically to iPod or iPhone, respectively, and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. Please note that the use of this accessory with iPod or iPhone may affect wireless performance. [. . . ]