User manual KENWOOD KDC-BT958HD

[. . . ] KDC-X998 KDC-BT958HD KDC-X898 KDC-BT858U CD-RECEIVER Quick Start Guide AMPLI-TUNER LECTEUR DE CD Guide de démarrage rapide Guía de inicio rápido REPRODUCTOR DE DISCOS COMPACTOS RECEPTOR DE FM/AM Take the time to read through this instruction manual. Familiarity with installation and operation procedures will help you obtain the best performance from your new CD-Receiver. For your records Record the serial number, found on the back of the unit, in the spaces designated on the warranty card, and in the space provided below. Refer to the model and serial numbers whenever you call upon your Kenwood dealer for information or service on the product. [. . . ] € Disconnect the battery’s negative terminal before installing the unit. € Insulate unconnected wires with vinyl tape or other similar materials. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires and terminals. € Be sure to ground this unit to the car’s chassis again after mounting. € If the fuse blows, first make sure the wires are not touching other parts to cause a short circuit, and then replace the old fuse with one with a new the same rating. € When connecting only two speakers, connect the connectors either to both of the front output terminals or to both of the rear output terminals (do not mix front and rear terminals). For example, if you connect the + connector of the left speaker to a front output terminal, do 10 | Quick Start Guide • not connect the - connector to a rear output terminal. Connect the speaker wires correctly to the corresponding terminals. The unit may be damaged or fail to work if you share the - wires or ground them to any metal part in the car. If your car’s ignition key switch does not have an ACC position, connect the ignition wires to a power source that can be turned on and off with the ignition key. If you connect the ignition wires to a constant-voltage power source, as with battery wires, the battery may die. If the console has a lid, make sure to install the unit so that the faceplate will not hit the lid when it is closed or opened. After the installing the unit, check whether the brake lamps, blinkers, wipers, etc. Mount the unit so that the mounting angle is 30° or less. Reception may become poor if there are metal objects near the Bluetooth antenna. 5 ft) For Good Reception To assure good reception, note the following: • Communicate with the cell phone within the line-of-sight distance of 10 m (30 ft). The communication range becomes shorter depending on the surrounding environment. The communication range also becomes shorter when there is an obstacle between this unit and the cell phone. The above maximum communication range (10 m) is not always assured. € A broadcast station or walkie-talkie located nearby can interfere with communication due to a too strong signal. Japanese cars • The frame can be removed from the bottom side in the same manner. 1 2 Remove the trim plate with reference to <Removing the trim plate>. [. . . ] € Download the iHeart Link application to your smartphone from the Google Play. € Bluetooth must be built in and the following profiles must be supported. - SPP (Serial Port Profile) - A2DP (Advanced Audio Distribution Profile) NOTE • In the application on your device, log in and create a free account with iHeartRadio. • Internet connection by LTE , 3G , EDGE , or WiFi. [. . . ]