User manual KENWOOD KDC-DAB43U

[. . . ] 13 About the Quick Start Guide This Quick Start Guide describes basic functions of this unit. For functions not described in this Guide, refer to the Instruction Manual stored in the enclosed CD-ROM. The Instruction Manual is subject to change for modification of specifications, etc. The latest Instruction Manual can be downloaded from the following website: manual. [. . . ] € If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. € Disconnect the battery’s negative terminal and make all electrical connections before installing the unit. € Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals. € Be sure to ground this unit to the car’s chassis again after mounting. € If the power is not turned ON (“PROTECT” is displayed), the speaker wire may have a short-circuit or touched the chassis of the vehicle and the protection function may have been activated. Therefore, the speaker wire should be checked. CAUTION • If your car’s ignition key switch does not have an ACC position, connect the ignition wires to a power source that can be turned on and off with the ignition key. If you connect the ignition wires to a constant-voltage power source, as with battery wires, the battery may die. € Install this unit in the console of your vehicle. Make sure the faceplate will not hit the lid of the console (if any) when closing and opening. € After the installing the unit, check whether the brake lamps, blinkers, wipers, etc. € Mount the unit so that the mounting angle is 30° or less. € If the fuse blows, first make sure the wires are not touching other parts to cause a short circuit, and then replace the old fuse with one with new one with the same rating. € Connect the speaker wires correctly to the corresponding terminals. The unit may be damaged or fail to work if you share the ¤ wires or ground them to any metal part in the car. 3 Insert the extraction key E deeply into the slots on each side, then follow the arrows instructions as shown on the right. E B C 3 1 A E 2 2 Make sure the direction of the trim plate. The shape of the hooks on the top side is as illustrated. 2 1 3 C Dashboard of your car 4 5 B A Bend the appropriate tabs to hold the mounting sleeve firmly in place. CAUTION • This film antenna is exclusively for use inside the vehicle. [. . . ] • Android and Chrome are trademark of Google Inc. € Internet Explorer and Windows Media are registered trademark of Microsoft Corporation in the United States and other countries. € Firefox is a registered trademark of Mozilla Foundation in the United States and other countries. € “Made for iPod” and “Made for iPhone” mean that an electronic accessory has been designed to connect specifically to iPod, or iPhone, respectively, and has been certified by the developer to meet Apple performance standards. [. . . ]