User manual KENWOOD KDC-W5137Y

[. . . ] In compliance with Federal Regulations, following are reproductions of labels on, or inside the product relating to laser product safety. KENWOOD CORPORATION 2967-3, ISHIKAWA-CHO, HACHIOJI-SHI TOKYO, JAPAN KENWOOD CORP. CERTIFIES THIS EQUIPMENT CONFORMS TO DHHS REGULATIONS N0. 21 CFR 1040. 10, CHAPTER I, SUBCHAPTER J. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] To cancel : Press the DISC REPEAT button. The D. REP indicator disappears and the Disc repeat function is canceled. NOTE · Input "0" to select disc 10. · If you input more than two numbers all at once, a search will be made only of the last number input. 2 Press either the + or ­ button while the number inputted is blinking. Canceling Direct Disc Search While It Is Operating : Press the 38 button. When disc play stops, Disc repeat is canceled. Track Scan Function of remote Successively play the beginning of each track on a disc until you find the track that you want to listen to. Starting the Track Scan: Press the T. SCAN button. The SCN indicator will appear on the display and the player will play the first 10 seconds of each track in succession. Stopping to Listen to the Track Being Scanned : Press the 38 or T. SCAN button. The SCN indicator disappears and the Track scan is canceled. Normal playback starts. NOTE Track Repeat Repeat playing the track currently being listened to. To repeat track : Press the REP (REPEAT. . . Remote) button. The REP indicator will appear on the display and the Track repeat function will turn on. To cancel : Press the REP (REPEAT. . . Remote) button. The frequency change mode is automatically canceled if you do nothing for 15 seconds. NOTE · The initial value is 88. 3MHz. · If this function is on, the functions other than power on / off, reset, and modulation level / dynamic control, cannot be operated. · This function is not available when the random play, repeat play, or scan play function is on. Before using this function, cancel the other functions. This function cannot be used while loading a disc (while the play indicator is blinking). 2 To change the frequency Press either the 4 or ¢ button. Each time you press the 4 or ¢ button, the mode switches as follows : 87. 7MHz 87. 9MHz 88. 1MHz 89. 9MHz 89. 7MHz 89. 5MHz 88. 3MHz (initial value) 89. 3MHz 88. 5MHz 88. 7MHz ¢ ¢ 89. 1MHz 88. 9MHz -- 12 -- Modulation level / Dynamic control 1 To set the control mode Press the RDM button on the display unit for at least three seconds. The LEVEL indicator will light up and the currently set modulation level will be displayed. Modulation level NOTE Dynamic control The unit comes with the prevention of distortion function to reduce sound distortion. If the sound is distorted severely, press the + button on the display unit and then set the function to "2" (ON). If the prevention of distortion function is set to "2" (ON), the sound extension is reduced. The initial setting is "1" (OFF). [. . . ] Set the angle adjustment switches to the correct positions. Connect the control output properly. The unit is mounted at a slant. Changer unit is mounted in an unstable place. The angle adjustment switches are set improperly. [. . . ]