User manual KENWOOD KDC-X592

[. . . ] KDC-X592 KDC-MP538U CD-RECEIVER INSTRUCTION MANUAL AMPLI-TUNER LECTEUR DE CD MODE D’EMPLOI REPRODUCTOR DE DISCOS COMPACTOS RECEPTOR DE FM/AM MANUAL DE INSTRUCCIONES Take the time to read through this instruction manual. Familiarity with installation and operation procedures will help you obtain the best performance from your new CD-receiver. For your records Record the serial number, found on the back of the unit, in the spaces designated on the warranty card, and in the space provided below. Refer to the model and serial numbers whenever you call upon your Kenwood dealer for information or service on the product. [. . . ]  • When you set the Bass Extend to ON, low frequency response is extended by 20%. € You can exit the Audio Control mode at anytime by pressing any button except for [AUD] knob, [0] and [ATT] button. Speaker Setting Range Through/40*1/ 60*1/80/100/ 120/150/180/220*1 Hz Through/40*1/ 60*1/80/100/ 120/150/180/220*1 Hz 50*1/60/80/100*1/120/ Through Hz Reverse (180°)/ Normal (0°) –8 — ±0 (AUX: -8— +8) OFF/ON OFF/ON Fine-tuning so that the System Q value is optimal when setting the speaker type as follows; Speaker type OFF For 5 & 4 in.  • Volume offset: Sets each source’s volume as a difference from the basic volume. € Loudness: Compensates for low and high tones during low volume. (Only the low tone is compensated for when the tuner is selected as a source. - Adjust the volume of Rear channel by <Audio Control> (page 15) or [5]/[∞] button on the remote control (page 20). 3 Select the Speaker type Turn the [AUD] knob. 4 Exit Speaker Setting mode Press the [AUD] knob. 1 Select the source to adjust For how to select source item, refer to <Power/ Source Select button> of <Basic Operation> (page 4). 2 Enter Audio Setup mode Press the [AUD] knob for at least 1 second. 3 Select the Audio Setup item to adjust Press the [AUD] knob. 4 Adjust the Audio setup item Turn the [AUD] knob. 5 Exit Audio Setup mode Press the [AUD] knob for at least 1 second. The memory cannot be erased by the Reset button. audio Preset Recall Recalling the sound setup registered by <Audio Preset Memory> (page 17). 1 Setup Sound Control Refer to the following operations to setup the Sound Control. - <Audio Control> (page 15) - <Audio Setup> (page 16) 1 Select the source For how to select source item, refer to <Power/ Source Select button> of <Basic Operation> (page 4). 2 Select Audio Preset item during Menu mode (Other than Standby mode) Select the “Audio Preset” display. for how to select Function Control items , refer to <Function Control> (page 6). 2 Select Audio Preset item during Menu mode (Other than Standby mode) Select the “Audio Preset” display. for how to select Function Control items , refer to <Function Control> (page 6). [. . . ] ž Wire or insulate the speaker cable properly and press the reset button. If the “Protect” code does not disappear, consult your nearest service center. USB ERROR (Blink): Some trouble may have occurred to the connected USB device. ž Remove the USB device, then cycle the power switch to ON. [. . . ]