User manual KENWOOD KDV-Z930

[. . . ] , it will not turn on and off along with the ignition). If you want to link the unit's power with the ignition, connect the ignition wire to a power source that can be turned on and off with the ignition key. If the console has a lid, make sure to install the unit so that the faceplate will not hit the lid when closing and opening. If the fuse blows, first make sure the wires aren't touching to cause a short circuit, then replace the old fuse with one with the same rating. [. . . ] If the fuse blows, first make sure the wires aren't touching to cause a short circuit, then replace the old fuse with one with the same rating. Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals. After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. If the parking brake is not engaged, "Parking Brake" appears on the monitor, and no playback picture will be shown. ­ This warning appears only when the parking brake lead is connected to the parking brake system built in the car. You cannot install the unit on the car which has any obstacles in the space indicated below. Fit the unit into the mounting sleeve by using four corners of the trim plate. The following parts are provided for this unit. After checking them, please set them correctly. DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit will be seriously damaged. BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in your car. If your car is equipped with the ISO connector / Wenn Ihr Fahrzeug mit dem ISO-Steckverbinder ausgestattet ist / SSi su automóvil está equipado con el conector ISO For some VW/Audi or Opel (Vauxhall) automobile / Bei bestimmten VW-/Audi- order Opel- (Vauxhall-) Fahrzeugen / Para algunos automóviles VW/Audi u Opel (Vauxhall) You may need to modify the wiring of the supplied power cord as illustrated. Contact your authorized car dealer before installing this unit. From the car body Use modified wiring 2 if the unit does not turn on. Conector ISO del cable de alimentación suministrado View from the lead side Connect the parking brake lead to the parking brake system built in the car. Connecting the REVERSE GEAR SIGNAL lead (for rear view camera) / Anschließen des REVERSE GEAR SIGNAL-Kabels (für die Rückfahrkamera) / Conexión del conductor REVERSE GEAR SIGNAL (para la cámara trasera) Incorrect connection may cause serious damage to this unit. The leads of the power cord and those of the connector from the car body may be different in color. 2 Connect the colored leads of the power cord in the order specified To the power control lead of other equipment or power aerial if any (200 mA max. *4 Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power cannot be turned on. [. . . ] The leads of the power cord and those of the connector from the car body may be different in color. 2 Connect the colored leads of the power cord in the order specified To the power control lead of other equipment or power aerial if any (200 mA max. *4 Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power cannot be turned on. You can connect amplifiers to upgrade your car stereo system. [. . . ]