User manual KENWOOD KEC-302

[. . . ] Be sure to use CDs with disc mark only for this unit. ⷠCD-Rs and CD-RWs which have not undergone finalization processing cannot be played. (For more information on finalization processing, refer to the manual for your CD-R/CD-RW writing software or CD-R/CD-RW recorder. ) Additionally, depending on the recording status, it may prove impossible to play certain CDs recorded on CD-R or CD-RW. [. . . ] ⷠIf it doesn't seem to be working properly, first press the Reset button. If the front panel is dirty, wipe it clean with a silicon cloth or soft dry cloth with the power off. Do not use hard cloths or paint thinner, alcohol, or other volatile solvents. Note that any control units released in 1997 or earlier cannot be connected to this unit. <KEC-302/C669> The disc name preset function can register names of up to 100 discs using up to 12 characters for each disc name. The availability of this function as well as the number of discs which can be registered using this function and the number of usable characters may be variable depending on the control unit in use. <KDC-C469> The disc name preset feature can store the names of up to 50 discs in memory. This feature may sometimes unable to be controlled from the control unit. In cold climates, there may be a period after you turn on your vehicle's heater when the lens that guides the laser beam used in your CD player fogs up. If this happens, you cannot play compact discs. take out discs and the fogging will disappear. The CD changer may be damaged during transport if a magazine or CD is left inside it or the transport screws are not attached. Way up with the "disc" logo on the top. Insert the tray into the disc magazine until it locks. check that the discs and trays are inserted properly. The discs are numbered from the bottom from 1 to 6 or 10. 2CAUTION · Take care to insert trays into the correct grooves in the disc magazine and to insert discs properly into the tray grooves. Otherwise malfunction may occur or the disc may be damaged. ⷠInsert all trays even when some of them do not carry discs. Otherwise malfunction or operation failure may occur. If an 8-cm disc adapter is used, the disc cannot be ejected. Insert the magazine into the CD changer until it clicks. [. . . ] ⷠDo not install an antenna of radio equipment or distribute the antenna cable near the changer output cable, for this could cause malfunction with this unit. Use the CD changer with its door closed to prevent the entry of dust into the changer. Be sure to open the door completely before pressing the EJECT button. If the door is not completely open, the magazine may hit the door and cause damage of malfunction. [. . . ]