User manual KENWOOD KNA-PG100

[. . . ] If any such object is accidentally swallowed, consult a doctor immediately. Caution Failure to avoid the following potentially hazardous situations may result in injury or property damage. · Make sure to ground the unit to the chassis of your vehicle. · Secure all wiring with cable clamps or electrical tape. [. . . ] · Do not let unconnected wires or terminals touch metal on the vehicle or anything else that can conduct electricity. · Do not open the top or bottom covers of the unit. · The KNA-PG100 is not waterproof. September 2006 Part Number 190-00736-01 Rev. A Printed in Taiwan What's Included GPS antenna and metal plate main unit screws (4) wiring harness hook and loop fasteners (2) Installing the main unit Caution Use the screws or the hook and loop fasteners provided to mount the main unit in the vehicle. Select a location that allows you to access the unit's SD card slot. Be sure to place the unit horizontally (flat) and secure it completely for best performance. · Do not install the unit where it will be exposed to direct sunlight, excessive heat or humidity, dust, spills, or liquids. If you use the wrong screws, you could damage the unit. · Check for cables or other parts underneath the floor mat before cutting the floor mat. Installing the GPS antenna Caution · Do not paint the antenna. This will impair or disable signal reception. Remove the key from the vehicle's ignition and disconnect the negative battery cable. Connect the wiring harness to your vehicle in the following order: ground, battery, ignition. Connect the wiring harness to the main unit. Reconnect the negative battery cable. Pink (KNA-G520 model only) (KNA-G520 model only) 4. Place the GPS antenna on top of the metal plate. Purple, white stripe To reverse lamp harness To display unit (NAV I/F terminal) WARNING Be sure to connect the parking brake wire to ensure safe navigation. Light green To parking brake detection switch WARNING To car speed signal harness Do not cut off the protection diode on the speed signal detection wire. Doing so can cause damage to the vehicle. Black To vehicle chassis Car fuse box (main fuse) 2A CAUTION If your vehicle's ignition does not have an ACC position, connect the ignition wires to a power source that can be turned on and off with the ignition key. If you connect the ignition wire to a power source with a constant voltage supply, as with battery wires, the vehicle's battery may die. Red To ignition (12 V) Car fuse box 2A Ignition key switch WARNING Yellow To battery (12 V) Do not connect the yellow wire lead directly to the vehicle battery. Connecting directly to the battery may cause the wire insulation to fail and may pose a risk of short circuit and electric shock. -3- Acquiring GPS Signals The first time you turn on the KNA-PG100, you must wait while the system acquires satellite signals for the first time. This process could take up to several minutes. [. . . ] This process could take up to several minutes. Make sure your vehicle is outdoors in an open area away from tall buildings and trees for fastest acquisition. After the system acquires satellites for the first time, it will acquire satellites quickly each time thereafter. Changing the Fuses If you need to replace a fuse on the red or yellow wires, make sure the wires are not touching to prevent a short circuit. [. . . ]