User manual KENWOOD KOS-L432

[. . . ] A/V controller you can control from the KOS-L432 (As of December, 2007): Products with the symbol (crossed-out wheeled bin) cannot be disposed as household waste. Old electrical and electronic equipment should be recycled at a facility capable of handling these items and their waste byproducts. contact your local authority for details in locating a recycle facility nearest to you. Proper recycling and waste disposal will help conserve resources whilst preventing detrimental effects on our health and the environment. [. . . ] If you use the wrong screws, you could damage the unit. â· If the fuse blows, first make sure that the wires have not caused a short circuit, then replace the old fuse with one with the same rating. â· Do not let unconnected wires or terminals touch metal on the car or anything else conducting electricity. To prevent short circuits do not remove the caps from unused terminals or from the ends of the unconnected wires. â· After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. Insulate unconnected wires with vinyl tape or other similar material. â· Thoroughly wipe away oil and other dirt from the installation surface. To prevent shorting, disconnect the battery cable from the negative terminal of the battery during installation. â· Be sure to firmly stabilise this product. Do not install it in a location which is not stable. â· Follow the installation and wiring procedures described in this manual. Improper wiring or modified installation can not only result in malfunction or damage to the unit but may also result in an accident. â· Do not install the unit in the following locations. â· A location which interferes with the operation of the air bag system. â· A location which is not made of plastic. \ Installing on leather, wood or cloth may damage the surface. â· A location subject to direct sunlight, subject to the air from the air conditioner, or subject to moisture or high temperature. If you are not going to install the unit using the supplied monitor stand, be sure to use a commercially available monitor stand. (Mounting holes for such a stand are located on the bottom of the monitor unit. For safety's sake, leave the mounting and wiring work to professionals. [. . . ] The user could lose the authority to operate this equipment if an unauthorized change or modification is made. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful interference to radio communications, if it is not installed and used in accordance with the instructions. [. . . ]