User manual KENWOOD KRF-V5050D

[. . . ] AUDIO VIDEO SURROUND RECEIVER KRF-V6050D KRF-V5050D INSTRUCTION MANUAL KENWOOD CORPORATION This instruction manual is used to describe multiple models listed above. Model availability and features (functions) may differ depending on the country and sales area. About the supplied remote control Compared to standard remote controls, the remote control supplied with this receiver has several operation modes. These modes enable the remote control to control other audio/video components. In order to effectively use the remote control it is important to read the operating instructions and obtain a proper understanding of the remote control and how to switch its operation modes (etc. ). [. . . ] · The adjustment item is displayed for approximately 8 seconds. KRF-V5050D 1 2 3 4 5 "PHONO" "TUNER" "CD/DVD" "TAPE" or "MD" "VIDEO1" if VIDEO2/MONITOR is VIDEO2 6 "VIDEO2" 7 "DVD/6ch" else if VIDEO2/MONITOR is MONITOR 6 "DVD/6ch" Once-touch low frequency emphasis (bass boost) (remote control only) You can adjust the sound quality when the receiver is in the PCM stereo and analog stereo mode. · Press the key once to select the maximum (+10dB) low frequency emphasis setting. · This key does not function when the receiver is in the sound quality or ambience effects adjustment mode. 2 Start playback from the selected source. 3 Use the VOLUME CONTROL knob (VOLUME keys) to adjust the volume. Selecting VIDEO 2/MONITOR Depending on the component connected to the VIDEO 2/MONITOR jacks, select either the "VIDEO 2" setting or the "MONITOR" setting, as appropriate. 8 Switching back to the previous setting Press the B. BOOST (BASS BOOST) key again. Normal playback Recording Recording audio (analog sources) MONITOR Muting the sound The MUTE key lets you mute the sound of the speakers. Press the MUTE key. SP A B TI. VOL MUTE CLIP RDS EON PTY TP TA NEWS 21 L LFE C S R SW LS RS Blinks To cancel Press the MUTE key again so that the "MUTE" indicator goes off. · MUTE ON can also be deactivated by turning the volume control knob. INPUT SELECTOR Recording a music source When recording a music source, switch the VIDEO2/MONITOR setting to "MONITOR". 8 1 Use the INPUT SELECTOR knob to select the source (other than "MD/TAPE") you want to record. 2 Set the cassette deck or MD recorder to record. 3 Start playback, then start recording. SOURCE DIRECT playback (for analog input sources only) Use this function to pass the source material direct to the amplifier, bypassing any audio processing. Press the SOURCE DIRECT key. FM AUTO SOUND DIGITAL AUTO AM PRO LOGIC S. DIRECT MEMO MHz 3 STEREO MONITOR ST. TUNED kHz DOWN MIX DSP To cancel Press the SOURCE DIRECT key again. · If SOURCE DIRECT playback was activated while in a surround mode, canceling SOURCE DIRECT playback will reactivate the previous surround mode. MONITOR = MD/TAPE recording 1 Press the MONITOR key. FM AUTO SOUND DIGITAL AUTO AM PRO LOGIC S. DIRECT MEMO MHz 3 STEREO MONITOR ST. TUNED kHz DOWN MIX DSP Listening with headphones 1 (KRF-V6050D) Press the SPEAKERS A or B key so that the speaker indicator goes off. (KRF-V5050D) Press the SPEAKER key so that the speaker indicator goes off. Make sure the SPEAKERS indicators are turned off. SP A B TI. VOL CLIP MUTE RDS EON PTY TP TA NEWS 2 Use the INPUT SELECTOR knob to select a source other than "MD/TAPE" 3 Start playback on the cassette deck connected to the MONITOR jacks and start recording on the cassette deck or MD recorder connected to the MD/TAPE jacks. MD/TAPE = MONITOR recording 1 Use the INPUT SELECTOR knob to select "MD/TAPE". 2 Start playback on the cassette deck connected to the MD/TAPE jacks and start recording on the cassette deck or MD recorder connected to the VIDEO2/MONITOR jacks. · To copy tapes using a double cassette deck, refer to the instruction manual of the double cassette deck. Make sure the SP indicators are turned off. R SP A B TI. VOL CLIP MUTE RDS EON PTY TP TA NEWS L LFE C S L LFE C S R SW SW LS RS LS RS KRF-V6050D KRF-V5050D · If you turn off all of the speakers when in the surround mode, the surround mode will be canceled as well, resulting in stereo playback. [. . . ] 40 Hz ~ 60 kHz, +0 dB, ­3. 0 dB Signal to noise ratio (IHF'66) PHONO (MM) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 74 dB CD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 90 dB Input sensitivity / impedance PHONO (MM) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2. 5 mV / 27 k CD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]