User manual KENWOOD KRF-V7030D

[. . . ] AUDIO VIDEO SURROUND RECEIVER KRF-V7030D KRF-V6030D KRF-V5030D KRF-V4530D INSTRUCTION MANUAL KENWOOD CORPORATION This instruction manual is used to describe multiple models listed above. Model availability and features (functions) may differ depending on the country and sales area. B60-4602-00 (EN) Remote Control Other Operations Preparations Before applying the power Units are designed for operation as follows. Caution : Read this page carefully to ensure safe operation. 2 Unpacking Unpack the unit carefully and make sure that all accessories are put aside so they will not be lost. Examine the unit for any possibility of shipping damage. If your unit is damaged or fails to operate, notify your dealer immediately. [. . . ] · The adjustment item is displayed for approximately 8 seconds. Once-touch low frequency emphasis (bass boost) You can adjust the sound quality when the receiver is in the PCM stereo and analog stereo mode. 2 Start playback from the selected source. 3 Use the VOLUME CONTROL knob (VOLUME keys) to adjust the volume. Press the B. · Press the key once to select the maximum (+10) low frequency emphasis setting. · This key does not function when the receiver is in the sound quality or ambience effects adjustment mode. Selecting VIDEO 2/MONITOR (except for KRF-V7030D) Depending on the component connected to the VIDEO 2/MONITOR jacks, select either the "VIDEO 2" setting or the "MONITOR" setting, as appropriate. 8 Switching back to the previous setting Press the B. BOOST (BASS BOOST) key again. Normal playback Recording Recording audio (analog sources) MONITOR 18 Muting the sound The MUTE key lets you mute the sound of the speakers. Press the MUTE key. SP A B TI. VOL MUTE CLIP RDS EON PTY TP TA NEWS L LFE C S R SW LS RS Blinks To cancel Press the MUTE key again so that the "MUTE" indicator goes off. · Muting can also be canceled by adjusting the volume. INPUT SELECTOR Recording a music source When recording a music source, switch the VIDEO2/MONITOR setting to "MONITOR" (KRF-V6030D/V5030D/V4530D only). 8 1 Use the INPUT SELECTOR knob to select the source (other than "MD/TAPE") you want to record. 3 Start playback, then start recording. SOURCE DIRECT playback (analog sources only) Use this function to pass the source material direct to the amplifier, bypassing any audio processing. Press the SOURCE DIRECT key. FM AUTO SOUND DIGITAL AUTO AM PRO LOGIC S. DIRECT MEMO MHz 3 STEREO MONITOR ST. TUNED kHz DOWN MIX DSP · When you press the LISTEN MODE, SOUND, or SETUP keys, or switch to another input source, SOURCE DIRECT playback will be canceled. Recording tapes When recording a music source, switch the VIDEO2/MONITOR setting to "MONITOR" (KRF-V6030D/V5030D/V4530D only). 8 Operations To cancel Press the SOURCE DIRECT key again. · If SOURCE DIRECT playback was activated when using a surround mode, cancelling it reactivates the previous surround mode. MONITOR = MD/TAPE recording 1 Press the MONITOR key. FM AUTO SOUND DIGITAL AUTO AM PRO LOGIC S. DIRECT MEMO MHz 3 STEREO MONITOR ST. TUNED kHz DOWN MIX DSP Listening with headphones 1 (KRF-V7030D/V6030D) Press the SPEAKERS A or B key so that the speaker indicator goes off. (KRF-V5030D/V4530D) Press the SPEAKER key so that the speaker indicator goes off. Make sure the SPEAKERS indicators are turned off. SP A B TI. VOL CLIP MUTE RDS EON PTY TP TA NEWS 2 Use the INPUT SELECTOR knob to select a source other than "MD/TAPE. " 3 Start playback on the cassette deck connected to the MONITOR jacks and start recording on the cassette deck connected to the MD/TAPE jacks. MD/TAPE = MONITOR recording 1 Use the INPUT SELECTOR knob to select "MD/TAPE. " 2 Start playback on the cassette deck connected to the MD/TAPE jacks and start recording on the cassette deck connected to the VIDEO2/MONITOR jacks. · To copy tapes using a double cassette deck, refer to the instruction manual of the double cassette deck. Make sure the SP indicators are turned off. R SP A B TI. VOL CLIP MUTE RDS EON PTY TP TA NEWS L LFE C S L LFE C S R SW SW LS RS LS RS KRF-V7030D/V6030D KRF-V5030D/V4530D · If you turn off all of the speakers when in the surround mode, the mode is cancelled as well, resulting in stereo playback. · The speakers do not switch off during the 6CH INPUT mode. 0 2 Connect headphones to the PHONES jack. PHONES MONITOR function (analog sources only) You can connect a cassette deck or graphic equalizer to the VIDEO2/ MONITOR jacks of the receiver. If a graphic equalizer is connected, the MONITOR key should be left in the on position. [. . . ] RC3 · Press the source select keys or source POWER keys to select the appropriate operation mode. · Operate the remote control unit within the controllable range. 35 · Connect properly referring to "Setting up the system". · Place software in the source component you want to play. · Wait until recording has completed. [. . . ]