User manual KENWOOD KRF-V7050D

[. . . ] AUDIO VIDEO SURROUND RECEIVER Preparations Additional Information Remote Control Operations KRF-V7050D INSTRUCTION MANUAL KENWOOD CORPORATION About the supplied remote control Compared to standard remote controls, the remote control supplied with this receiver has several operation modes. These modes enable the remote control to control other audio/video components. In order to effectively use the remote control it is important to read the operating instructions and obtain a proper understanding of the remote control and how to switch its operation modes (etc. ). Using the remote control without completely understanding its design and how to switch the operation modes may result in incorrect operations. B60-5029-00 00 MA (T) PR 0009 Before applying the power Units are designed for operation as follows. Caution : Read this page carefully to ensure safe operation. 2 Unpacking Unpack the unit carefully and make sure that all accessories are put aside so they will not be lost. [. . . ] TUNED kHz DOWN MIX DSP Recording tapes or MD (with MONITOR function) MONITOR = MD/TAPE recording 1 Press the MONITOR key. FM AUTO SOUND DIGITAL AUTO AM PRO LOGIC S. DIRECT MEMO MHz 3 STEREO MONITOR ST. TUNED kHz DOWN MIX DSP · When you press the LISTEN MODE, SOUND, or SET UP keys, or switch to another input source, SOURCE DIRECT playback will be canceled. is switched ON, SOURCE DIRECT key will not be effective. · If SOURCE DIRECT is switched ON, CINEMA EQ. function will not be effective. Operations 2 Use the INPUT SELECTOR knob to select a source other than "MD/TAPE" 3 Start playback on the cassette deck connected to the MONITOR jacks and start recording on the cassette deck or MD recorder connected to the MD/TAPE jacks. MD/TAPE = MONITOR recording 1 Use the INPUT SELECTOR knob to select "MD/TAPE". To cancel Press the SOURCE DIRECT key again. · If SOURCE DIRECT playback was activated while in a surround mode, canceling SOURCE DIRECT playback will reactivate the previous surround mode. Listening with headphones 1 Press the SPEAKERS A or B key so that the speaker indicator goes off. Make sure the SPEAKERS indicators are turned off. SP A B TI. VOL CLIP MUTE RDS EON PTY TP TA NEWS 2 Start playback on the cassette deck connected to the MD/ TAPE jacks and start recording on the cassette deck or MD recorder connected to the MONITOR jacks. · To copy tapes using a double cassette deck, refer to the instruction manual of the double cassette deck. L LFE C S R SW MONITOR function (analog sources only) You can connect a cassette deck or graphic equalizer to the MONITOR jacks of the receiver. If a graphic equalizer is connected, the MONITOR key should be left in the on position. Alternately, if a cassette deck equipped with a 3-head system is connected to the MONITOR jacks, you will be able to monitor the just-recorded signal while making recordings on the cassette deck. By switching the MONITOR key on and off, you can compare the sound of the source signal and the justrecorded signal. For more information, refer to the instruction manual of the connected component. LS RS · If you turn off all of the speakers when in the surround mode, the surround mode will be canceled as well, resulting in stereo playback. 2 Connect the headphones to the PHONES jack. PHONES 3 Use the VOLUME CONTROL knob or VOLUME keys to adjust the volume. Continued to next page Recording Recording video For A-REC mode: 1 Use the INPUT SELECTOR to select the video source (other than "VIDEO1") you want to record. 2 Set the video deck connected to VIDEO 1 to record. · Select the REC MODE to record a digital input source. · Recording may not be normal for some video software. This is due to the copy guard condition. fl AUTO SOUND DIGITAL AUTO FM AUTO SOUND DIGITAL AM PRO LOGIC S. DIRECT MEMO MHz 3 STEREO MONITOR ST. TUNED kHz DOWN MIX DSP 21 AUTO SOUND DIGITAL AUTO FM AUTO SOUND DIGITAL AM PRO LOGIC S. DIRECT MEMO MHz 3 STEREO MONITOR ST. TUNED kHz DOWN MIX DSP For M-REC mode: AUTO FM AUTO SOUND DIGITAL AM PRO LOGIC S. DIRECT MEMO MHz 3 STEREO MONITOR ST. kHz DOWN MIX DSP DIGITAL AU GITAL TUNED Recording audio (digital sources) Switch on the REC mode to record a digital input source. [. . . ] 0. 8% (65. 2 dBf input) Signal to noise ratio (DIN weighted) MONO . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 65. 2 dBf input) STEREO . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 65. 2 dBf input) Stereo separation (DIN 1 kHz) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36 dB Selectivity (DIN ± 300 kHz) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]