User manual KENWOOD KRF-V8010D

[. . . ] AUDIO VIDEO SURROUND RECEIVER Preparation Remote Control Other Operations KRF-V8010D INSTRUCTION MANUAL KENWOOD CORPORATION About the supplied remote control . . Compared to standard remote controls, the remote control supplied with this receiver has several operation modes. These modes enable the remote control to control other audio/video components. In order to effectively use the remote control it is important to read the operating instructions and obtain a proper understanding of the remote control and how to switch its operation modes (etc. ). [. . . ] · The bass and treble levels are adjustable from -10 to +10 in 2 step increments. · The adjustment item is displayed for approximately eight seconds. · If you used the remote control to perform the above setting, press the VIDEO key at this point to turn off the remote control's own adjustment mode. In this case, the input source is not switched. * Once setup codes are registered in the remote control, the input name display changes according to the name of the registered component. Example: if you register a VCR at the VIDEO 1 jacks, "VCR" appears instead of "VIDEO 1". RC2 · When using the remote control after initial setup, any inputs that have not been registered with a setup code are deleted from the cyclic list. RC4 · The INPUT SELECTOR on the front panel of the receiver always cycles through all inputs. Once-touch low frequency emphasis (bass boost) If a source that is not Dolby Digital is selected, you can adjust the sound quality when the receiver is in the stereo mode. · Press the key once to select the maximum (+10) low frequency emphasis setting. · This key does not function when the receiver is in the sound quality or ambience effects adjustment mode. 2 Start playback from the selected source. 3 Use the VOLUME CONTROL (VOLUME) to adjust the volume. Switching back to the previous setting Press the BASS BOOST key again. Normal playback Recording KRF-V8010D (En/T) Recording audio Muting the sound MUTE lets you mute the sound of the speakers. Press the MUTE key. SP 17 MONITOR A MUTE L R SW Blinks CD Recording a music source INPUT SELECTOR To cancel Press the MUTE key again so that the "MUTE" indicator goes off. · Muting can also be cancelled by adjusting the volume. 1 Use the input selector to select the source (other than "TAPE") you want to record. 3 Start playback, then start recording. SOURCE DIRECT playback (analog sources only) Use this function to pass the source material direct to the amplifier, bypassing any audio processing. Press the SOURCE DIRECT key. AUTO SOUND AUTO S. DIRECT MEMO. TUNED Copying tapes MONITOR = TAPE copying 1 Press the MONITOR key. AUTO SOUND AUTO MEMO. · If SOURCE DIRECT playback was activated when using a surround mode, cancelling it reactivates the previous surround mode. 2 Use the input selector to select a source other than "TAPE. " 3 Start playback on the cassette deck connected to the MONITOR jacks and start recording on the cassette deck connected to the MD/TAPE jacks. Listening with headphones 1 Press the SPEAKERS A or B key so that the speaker indicator goes off. Make sure the SPEAKERS indicators are turned off. SP TAPE = MONITOR copying 1 Use the input selector to select "TAPE. " 2 Start playback on the cassette deck connected to the MD/TAPE jacks and start recording on the cassette deck connected to the MONITOR jacks. · To copy tapes using a double cassette deck, refer to the instruction manual of the double cassette deck. A C PHONES MONITOR function (analog sources only) You can connect a cassette deck or graphic equalizer to the MONITOR jacks of the receiver. If a graphic equalizer is connected, the MONITOR key should be left in the on position. Alternately, if a cassette deck equipped with a 3-head system is connected to the MONITOR jacks, you will be able to monitor the just-recorded signal while making recordings on the cassette deck. By switching the MONITOR key on and off, you can compare the sound of the source signal and the just-recorded signal. For more information, refer to the instruction manual of the connected component. · If you turn off all of the speakers when in the surround mode, the mode is cancelled as well, resulting in stereo playback. [. . . ] 1 V / 600 Tone control BASS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±10 dB (at 100 Hz) TREBLE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±10 dB (at 10 kHz) VIDEO section VIDEO inputs / outputs VIDEO (composite) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Vp-p / 75 FM tuner section Tuning frequency range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]