User manual KENWOOD KS-308EX

[. . . ] Refer to these model and serial numbers whenever you call upon your KENWOOD dealer for information or service on this product. Model KS-3200HT is composed of the front speakers, center speaker and surround speakers. Model KS-5200HT is composed of the front speakers, center speaker and surround speakers. Model KS-308EX is composed of the front speakers, center speaker, surround speakers and surround back speaker. [. . . ] Suffocation ­ After taking the unit out of the polyethylene bag, be sure to dispose of the polyethylene bag out of the reach of children. Otherwise, they may play with the bag, which could cause hazard of suffocation. Water and moisture ­ The appliance should not be used near water - for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc. Heat ­ Do not install the unit near a source of heat, such as radiators, or under direct sunlight. Modification ­ Do not attempt to open or modify the unit, for this could cause fire hazard or malfunction. Cleaning ­ Do not use volatile solvents such as alcohol, paint thinner, gasoline, or benzine, etc. Abnormal smell ­ If an abnormal smell or smoke is detected, immediately turn the power OFF and unplug the appliance from the wall outlet. This speaker system can provide full Surround sound. To enjoy the full effect of the Surround sound field, please position the speakers as described below. Place the left and right speakers at each side of your TV. Screw each screw only part way in, so that the screw projects 8 to 10 mm (5/16 to 3/8 inches) outward from the wall surface. Please observe the following precautions when mounting speakers onto the wall. Be sure that the wall you are using is strong enough to support the full weight of the speaker (approx. Wall screws must be purchased separately. Be sure to use screws that are appropriate for the wall you are using, and that are long enough to provide sufficient strength. If you are uncertain about the wall's support strength, the type of screw to use, or any other points regarding this type of installation, please consult a contractor or other qualified person before proceeding. Be sure to follow the procedure given here when carrying out installation. Kenwood can assume no liability for injury or damage that may occur if a speaker setup falls from the wall as a result of incorrect installation or insufficient support strength. 7 On the optional kenwood stand (SR-8000) (front speaker and surround speaker only) The speaker can be installed on the SR-8000 stand optionally available from KENWOOD. 7 On the commercially available speaker mount or bracket (front speaker only) Any commercially available speaker mount or bracket can also be used (provided that the speaker can be fixed using an M5 screw with a pitch of 60 mm and E ffe c t i ve t h r e a d effective thread length of 10 to 13 length mm). [. . . ] 7 On the commercially available speaker mount or bracket (front speaker only) Any commercially available speaker mount or bracket can also be used (provided that the speaker can be fixed using an M5 screw with a pitch of 60 mm and E ffe c t i ve t h r e a d effective thread length of 10 to 13 length mm). The cushions prevent the speaker from sliding, and dampen its vibrations. The speaker wires and labels of speakers' back panel are color-coded to facilitate connection. connect each wire to the matchingcolored terminal , as shown in the figure. [. . . ]