User manual KENWOOD KSC-310CCS

[. . . ] Suffocation ­ After taking the unit out of the polyethylene bag, be sure to dispose of the polyethylene bag out of the reach of children. Otherwise, they may play with the bag, which could cause hazard of suffocation. Do not install the speaker in a spot exposed to direct sunlight or excessive heat or humidity. [. . . ] Water and moisture ­ Do not install the speakers in locations which may be subject to water or moisture. Dust and unstable locations ­ Do not install the speakers in unstable locations or locations subject to dust. If the fuse blows, after checking to see if the wiring cord has shorted, be sure to replace with the stipulated size (amperage) fuse as displayed on the fuse box. (Using fuses other than the stipulated size can cause fires. To prevent a short circuit when replacing a fuse, disconnect the wiring harness at first. Do not use gasoline, naphtha, or any type of solvent to clean the speaker. connect the speaker wires to appropriate speaker connectors separately. Be careful not to cover the air-conditioning vent when mounting. 4 Speed nut × 2 4 Ecrou rapides × 2 Remove the cover paper from bracket 2 and attach it to the dashboard so that arrow points towards the passenger. Mount bracket 2 on the dashboard with the tap screws ( 4 × 16) 3 and speed nut 4. make Sure To: · Mount in a place near the center of the vehicle where it will not interfere with driving and as level as possible. Attach after thoroughly cleaning and drying the mounting place with the cleaner (sold separately). When bringing out the speaker cord from the back, slide the cord along the slot on the bottom of the speaker 1, and fix by hooking the cord between the notches. Insert the two back side lugs of the bracket 2 into the back two holes of the speaker. [. . . ] Insert the two back side lugs of the bracket 2 into the back two holes of the speaker. The back side lug Barrette côté arrière The front side lug Barrette côté avant Insert the two front side lugs of the bracket 2 into the front two holes of the speaker, by pulling the speaker 1 towards the front. Fix completely by pushing down the front of the speaker 1. [. . . ]