User manual KENWOOD KSC-510CTR

[. . . ] Dust and unstable locations ­ Do not install the speakers in unstable locations or locations subject to dust. If the fuse blows, after checking to see if the wiring cord has shorted, be sure to replace with the stipulated size (amperage) fuse as displayed on the fuse box. (Using fuses other than the stipulated size can cause fires. To prevent a short circuit when replacing a fuse, disconnect the wiring harness at first. [. . . ] connect the speaker wires to appropriate speaker connectors separately. Sharing the negative wire of the speaker or grounding speaker wires to the metal body of the car can cause this unit to fail. Do not connect cables and leads to both RCA cord input jacks and the speaker input terminals simultaneously, for this may cause malfunction or damage. When making a hole under a seat, inside the trunk, or somewhere else in the vehicle, check that there is nothing hazardous on the opposite side such as a gasoline tank, brake pipe; or wiring harness, and be careful not to cause scratches or other damage. For ground wire mounting, do not fasten the wire to an airbag, steering or brake line system or other critical safety unit bolts or nut. ) When mounting, be sure to mount in a place that will not interfere with driving or be dangerous to passengers during sudden braking etc. ) After installing the unit, check to make sure that electrical equipment such as the brake lamps, turn signal lamps and windshield wipers operate normally. Before installing the speaker or making any connections, please read all of this instruction manual carefully, to make sure that you perform these operations correctly. For your records Record the serial number, located on the back of the amplifier in the spaces designated on the warranty card, and in the space provided below. Refer to this model's name and serial number whenever you call upon your KENWOOD dealer for information or service on this amplifier. Model KSC-510CTR Serial number __________________ Safety Precautions In a situation where the car has been left in direct sunlight with its windows closed and the temperature inside the car has risen to a very high level, switch on the air conditioner or drive the car for awhile with the windows open before operating the car stereo. Finally, lightly shake the speaker unit to check that it is securely fixed. Insert the fuse gently into the fuse holder and push in all Removal : 1. Open the cover the way with your finger. Caution: ­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­ Be sure to replace with same capacity (amperage) as displayed on the fuse. Turn the LOW PASS FREQUENCY control knob to adjust the balance between the bass from the rear speakers and the bass from this unit as desired. The low frequency tone may be variable depending on the position of the unit, its orientation or the turn-over frequency. this can be adjusted by changing the position of the PHASE switch. Set this switch to either position according to your liking. Turn-over frequency: The frequency at which the high range is cut off. Connect with the lock part of remote control jack facing down . 9 Remote control 9 Télécommande Caution: ­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­ Install the remote control unit in a position that does not come in the way of driving operations. [. . . ] Avoid installing it in a place subject to direct sunlight or direct hot wind from the heater. Remove dirt from the installation position before attaching the Velcro tape. When the Velcro tape is attached on the remote control unit, it cannot be accommodated in the main unit. Often, what appears to be a malfunction is due to user error. [. . . ]