User manual KENWOOD KTC-V300N

[. . . ] If the unit starts to emit smoke or strange smells, turn off the power immediately and consult your Kenwood dealer. Make sure not to get your fingers caught between the faceplate and the unit. Be careful not to drop the unit or subject it to strong shock. The unit may break or crack because it contains glass parts. [. . . ] Each time the button is pressed for at least 1 second the Loudness turns ON or OFF. Enter Audio Control mode Press the [AUD] button for at least 1 second. select the Audio item for adjustment Press the [FM] or [AM] button. Each time the button is pressed the items that can be adjusted switch as shown below. adjust the Audio item Press the [4] or [¢] button. Adjustment Item Display Bass level "BAS" Middle level "MID" Treble level "TRE" Balance "BL" Fader "FD" Exit Audio Control mode Press the [AUD] button. You can recall the best sound setting preset for different types of the music. Each time the button is pressed the sound setting switches. Each setting value is changed with the <Speaker setting> (page 8). First, select the speaker type with the Speaker setting. When the System Q setting is changed, the Bass, Middle, and Treble set in audio control replace the System Q values. Each time the button is pressed the Track Repeat turns ON or OFF. Using an adapter and inserting them into this unit can cause damage. Playing the first part of each song on the disc you are listening to and searching for the song you want to listen to. Release your finger to play the disc at that point. Release your finger to play the disc at that point. Release it when the song you want to listen to is played Press the [SCAN] button. Each time the button is pressed Random Play turns ON or OFF. When it's ON, the "RDM" indicator is ON and the track number blinks. When the [¢] button is pressed, the next song select starts. The use of any accessories except for those provided might result in damage to the unit. Make sure only to use the accessories shipped with the unit, as shown above. [. . . ] Remove the screw (M4×8) on the back panel. Insert the two removal tools deeply into the slots on each side, as shown. When the lower level is removed, remove the upper two locations. Lower the removal tool toward the bottom, and pull out the unit halfway while pressing towards the inside. [. . . ]