User manual KENWOOD KTC-V800N

[. . . ] ­ A place where a heat reflection glass or mirror-type glass film is affixed ­ A place where the film antenna of the factory-supplied radio already exists ­ On the window where the heating wire already exists ­ On the side of the vehicle (door, front quarter window, etc. ) ­ On the rear window ­ On a glass (heat reflecting glass, heat insulating glass, etc. Using the cleaner (Accessory 0), remove oil and dirt from the glass surface to which the film antennas are to be affixed. [. . . ] Using the cleaner (Accessory 0), remove oil and dirt from the glass surface to which the film antennas are to be affixed. ⷠIf the ambient temperature is low, warm the glass before starting the work. ⷠBefore starting the work, confirm well the places where the film antennas (Accessory 1 and 2) and the cables (Accessory 3 and 4) are to be installed. Once peeled off, the film antennas and double-stick tape lose adhesion. Noise generated by the air conditioner or monitor can cause poor TV reception. The reception sensitivity can vary with the windshield wiper operation depending on the vehicle model. ⷠThe reception sensitivity can vary depending on the relationship between the traveling direction of the vehicle (the pointing direction of the antennas) and the location of the broadcast station. To prevent short circuits, remove the key from the ignition and disconnect the - terminal of the battery. 1) Peel off the release paper (halftransparent sheet) 1 starting at the slit, and then affix the film antenna to the windshield. Once peeled off, the remaining portions of the antenna cannot be affixed again. 2) Peel off the release paper 2 starting at either slit, and affix the film antenna to the windshield. 3) Peel off the release paper 3 and release paper 4 and affix the film antenna to the windshield in the same manner as above. Either the left or right side of the film antenna can be affixed first. ⷠInserting the release paper 1 under the corner of the film antenna as shown on the right allows you to peel off other sheets of release paper easily. If the rubber spatula is not available, use a small board wrapped with cloth. Slowly peel off the transparent Affix the cable connector in such a manner that the bare portions of the antenna element are aligned with the line shape protrusions of the cable connector. [. . . ] ⷠInserting the release paper 1 under the corner of the film antenna as shown on the right allows you to peel off other sheets of release paper easily. If the rubber spatula is not available, use a small board wrapped with cloth. Slowly peel off the transparent Affix the cable connector in such a manner that the bare portions of the antenna element are aligned with the line shape protrusions of the cable connector. [. . . ]