User manual KENWOOD KTF-3010

[. . . ] FM/MW/LW TUNER KTF-2010 KTF-3010 INSTRUCTION MANUAL KENWOOD CORPORATION B60-3703-00 00 MA ( E2, T ) OC 99/12 11 10 9 8 7 6 5 4 3 2 1 98/12 11 10 9 8 7 6 5 4 3 2 1 Before applying power Units are designed for operation as follows. Caution : Read this page carefully to ensure safe operation. KTF-3010/KTF-2010 (En) 2 Europe , U. K. and Russia . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 230 V only For the United Kingdom Factory fitted moulded mains plug 1. The mains plug contains a fuse. For replacement, use only a 13-Amp ASTA-approved (BS 1362) fuse. [. . . ] Press the numeric keys (0 to 9, +10) in the following order. To select "15". . . 0, 5 To select "20". . . 0, 0, ) ÷ Repeat steps 1 to 3 for each of the stations to be stored in memory. ÷ If a station is stored in a preset number which already stores a station memory under it, the previous memory is replaced by the new memory content. ÷ Once the memory content has been preset, it is held for about 3 days even after the power cord is unplugged from the mains outlet. ÷ You cannot enter numbers over 40. ÷ If you make a mistake when pressing the 0 key, press the 0 key several times to return to the original display before re-entering. ÷ The stored station will be erased from the memory. Receiving a preset station KTF-3010/KTF-2010 (En) The figure shows an example for the KTF-3010 AM-FM STEREO SYNTHESIZER TUNER KTF-3010 HIGHBLEND WIDE ACTIVE RECEPTION NARROW IF BAND PTY/ PTY SCARCH RF ATT ANT A/B RFATT EON RDS 11 TUNING/MULTI CONTROL DOWN UP BAND TA/NEWS ON/STANDBY DISPLAY MEMORY TUNING MODE +10/CLEAR P. CALL 1 2 3 4 5 6 7 8 9 0/CHARA. : Keys or controls to be used in this operation. Receiving a preset station 1 Set to the Call up (Sellect) mode. P. CALL STANDBY AR MEMO ANT A B AM FM P5CALL 0 STEREO TUNED AUTO kHz 2 Select one of the preset numbers. TUNING/MULTI CONTROL DOWN UP ÷ Press P. CALL key once more to cancel the call up mode and return to the original display. [ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ] Blinks for 5 sec. STANDBY AR ANT A B AM FM 26 9 ) . ) ) STEREO TUNED AUTO kHz MHz When you stop turning the knob, you tune in on the preset station. Instead of steps 1 and 2, you can use the numeric keys (0~9, +10), to store the broadcast stations. Press the numeric keys (0 to 9, +10) in the following order. To select "15". . . 0, 5 To select "20". . . 0, 0, ) ÷ While the display is blinking, you can select the next station. ÷ If the tuner has stored a preset station name or program service name, each will be displayed. ÷ You cannot enter numbers over 40. ÷ If you make a mistake when pressing the 0 key, press the 0 key several times to return to the original display before re-entering. Memory back up Even if the power cord is unplugged from the AC outlet, the preset memory contents will be backed up for 3 days. Last channel memory When the power is turned ON or the BAND key is pressed to switch the band, the last station previously received is automatically tuned in. Displaying broadcast station names KTF-3010/KTF-2010 (En) 12 The figure shows an example for the KTF-3010 Preparation AM-FM STEREO SYNTHESIZER TUNER KTF-3010 HIGHBLEND WIDE ACTIVE RECEPTION NARROW IF BAND PTY/ PTY SCARCH RF ATT ANT A/B RFATT EON RDS TUNING/MULTI CONTROL Switch the ON/STANDBY key to ON. ON/STANDBY BAND TA/NEWS DISPLAY MEMORY TUNING MODE +10/CLEAR P. CALL DOWN UP 1 2 3 4 5 6 7 8 9 0/CHARA. : Keys or controls to be used in this operation. Entering broadcast station names 1 Call up (select) the preset station. Follow the steps in "Receiving a preset station" to call up stored stations with no PS display, MW stations and LW stations. STANDBY AR ANT A B AM FM ! )8 89 )) STEREO TUNED AUTO kHz MHz 2 Select the Entry mode. Press the 0/CHARA. key 7 8 9 0/CHARA. [ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ] AR ANT A B AM FM ÷ The entry mode will be cancelled unless the next steps are completed within 10 seconds. ÷ The station name cannot be entered if "PS" is displayed. -1 8 9; 0 0 STEREO TUNED AUTO kHz MHz 3 Enter the characters. 1 Select the characters and symbols using the TUNING/MULTI CONTROL knob. TUNING/MULTI CONTROL [ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ] You can select from the following characters and symbols. A, B, C. . . . . X, Y, Z, 0, 1, 2, 3. . . . . 8, 9, +, -, , / , * Space The selected characters will blink. DOWN UP STANDBY AR MEMO ANT A B 2 Press the 0/CHARA. The cursor will move to allow the next entry. 7 8 9 0/CHARA. AM FM A B 1 2 + -; 0 0 STEREO TUNED AUTO kHz Enter up to 8 characters. 3 Repeat steps 1 and 2. [. . . ] 68 dB Sub carrior suppression ratio (DIN) . . . . . . . . . . . . 55 dB (at 19 kHz) 65 dB (at 38 kHz) Frequency response (30 Hz ~ 15 kHz) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +0. 5 dB, ­1. 5 dB Output level / impedance (FM at 1 kHz, 75 kHz dev. ) Fixed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0. 6 V/600 MW (AM) tuner section Tuning frequency range . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]