User manual KENWOOD KVT-522DVD INSTALLATION MANUAL

[. . . ] Take Connector B on the wiring harness and connect it to the speaker connector in your vehicle. Take Connector A on the wiring harness and connect it to the external power connector on your vehicle. [. . . ] If you use the wrong screws, you could damage the unit. · If the power is not turned ON ("PROTECT" is displayed), the speaker wire may have a short-circuit or touched the chassis of the vehicle and the protection function may have been activated. Therefore, the speaker wire should be checked. · Make sure that all wire connections are securely made by inserting jacks until they lock completely. · If your vehicle's ignition does not have an ACC position, or if the ignition wire is connected to a power source with constant voltage such as a battery wire, the power will not be linked with the ignition (i. e. , it will not turn on and off along with the ignition). If you want to link the unit's power with the ignition, connect the ignition wire to a power source that can be turned on and off with the ignition key. · Use a commercially available conversion connector if the connector does not fit in the vehicle connector. · Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals. 2| KVT-522DVD/KVT-522DVDY/KVT-50DVDRY Connecting Wires to Terminals Connector Function Guide Pin Numbers for ISO Connectors External Power Connector A-4 A-5 A-6 A-7 A-8 Speaker Connector B-1 B-2 B-3 B-4 B-5 B-6 B-7 B-8 Cable Colour Functions 2WARNING Connecting the ISO Connector The pin arrangement for the ISO connectors depends on the type of vehicle you drive. Make sure to make the proper connections to prevent damage to the unit. The default connection for the wiring harness is described in 1 below. If the ISO connector pins are set as described in 2 or 3, make the connection as illustrated. Please be sure to reconnect the cable as shown 2 below to install this unit to the Volkswagen vehicles etc. Yellow Blue/White Orange/White Red Black Battery Power Control Dimmer Ignition (ACC) Earth (Ground) Connection Purple Purple/Black Gray Gray/Black White White/Black Green Green/Black Rear Right (+) Rear Right (­) Front Right (+) Front Right (­) Front Left (+) Front Left (­) Rear Left (+) Rear Left (­) 1 (Default setting) The A-7 pin of the vehicle's ISO connector is linked with the ignition, and the A-4 pin is connected to the constant power supply. Ignition cable (Red) Unit Battery cable (Yellow) A-4 Pin A-7 Pin Vehicle 2 The A-7 pin of the vehicle's ISO connector is connected to the constant power supply, and the A-4 pin is linked to the ignition. Ignition cable (Red) Unit Battery cable (Yellow) A-4 Pin A-7 Pin Vehicle 3 The A-4 pin of the vehicle's ISO connector is not connected to anything, while the A-7 pin is connected to the constant power supply (or both the A-7 and A-4 pins are connected to the constant power supply). Ignition cable (Red) Unit Battery cable (Yellow) A-4 Pin A-7 Pin Vehicle / · When the connection is made as in 3 above, the unit's power will not be linked to the ignition key. For that reason, always make sure to turn off the unit's power when the ignition is turned off. [. . . ] Insert the two removal tools 3 deeply into the slots on each side, as shown. Removal Tool (Accessory 3) Catch Lock / · The frame can be removed from the top side in the same manner. 4. Lower the removal tool toward the bottom, and pull out the unit halfway while pressing towards the inside. 2. [. . . ]