User manual KENWOOD LS-5070ES

[. . . ] Place the center speaker on the center between the front left and right speakers. The subwoofer's deep-bass reproduction characteristics are richest when the subwoofer is installed in a corner or near a wall. Place the surround speakers straight to or diagonally behind the left and right of the listening position. Place the surround back speaker behind the listining position, at the same height as the left and right surround speakers. [. . . ] Place the surround back speaker behind the listining position, at the same height as the left and right surround speakers. Caution: Read this item carefully to keep your safety. Suffocation ­ After taking the unit out of the polyethylene bag, be sure to dispose of the polyethylene bag out of the reach of children. Otherwise, they may play with the bag, which could cause hazard of suffocation. Water and moisture ­ The appliance should not be used near water - for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc. Heat ­ Do not install the unit near a source of heat, such as radiators, or under direct sunlight. Modification ­ Do not attempt to open or modify the unit, for this could cause fire hazard or malfunction. Cleaning ­ Do not use volatile solvents such as alcohol, paint thinner, gasoline, or benzine, etc. Abnormal smell ­ If an abnormal smell or smoke is detected, immediately turn the power OFF and unplug the appliance from the wall outlet. This speaker include magnetic shielding and can therefore be installed close to a TV set. These piles will protect the speaker body from damage and prevent the vibrations of the speaker body from being transmitted to the wall. The speaker can be installed on the SR-8000 stand optionally available from KENWOOD. Any commercially available speaker mount or bracket can also be used (provided that the speaker can be fixed using an M5 screw with a pitch of 60 mm and effective thread length of 7 to 10 mm). Please observe the following precautions when mounting the speaker onto the wall or speaker stand. Be sure that the wall you are using is strong enough to support the full weight of the speaker (approx. Wall screw must be purchased separately. Be sure to use a screw that is appropriate for the wall or stand you are using, and that are long enough to provide sufficient strength. If you are uncertain about the wall's support strength, the type of screw to use, or any other points regarding this type of installation, please consult a contractor or other qualified person before proceeding. Be sure to follow the procedure given here when carrying out installation. Kenwood can assume no liability for injury or damage that may occur if a speaker setup falls from the wall as a result of incorrect installation or insufficient support strength. [. . . ] If you are uncertain about the wall's support strength, the type of screw to use, or any other points regarding this type of installation, please consult a contractor or other qualified person before proceeding. Be sure to follow the procedure given here when carrying out installation. Kenwood can assume no liability for injury or damage that may occur if a speaker setup falls from the wall as a result of incorrect installation or insufficient support strength. Be sure to turn off your amplifier before connecting or disconnecting speakers. [. . . ]